I am using an 8G CF card. (I was using dd to duplicate the card with
different size cards I was advised not to).
So I wrote the script below which basically:
1) runs fdisk to setup the device
2) makes the ext3 file system and the swap
3) mounts my old image "/" filesystem and the new partition
4) tar and untar the directories
5) run grub on it
6) set label for "/"
After I run all the above I get:
EXT3-fs error ext3_find_entry reading directory #129586 offset 0
then a couple lines later it remounts the root file system read only.
What have I missed in successfully make the CF card based on the old image?
Jerry
---------
DEVICE=/dev/sde
PARTITION_1=/dev/sde1
PARTITION_2=/dev/sde2
fdisk $DEVICE << EOF
o
n
p
1
+7000M
n
p
2
t
2
82
a
1
w
EOF
echo ""
fdisk -l $DEVICE
echo ""
mke2fs -j $PARTITION_1
mkswap $PARTITION_2
# mount the first partition in the image file
mount -t ext3 -o loop,offset=32256 ebox4300.centos.5.5.cf.img /mnt/from_image
mount -t ext3 $PARTITION_1
/mnt/to_image
PUSH_PWD=`pwd`
# Directories to copy
cd /mnt/from_image
for DIRECTORY in bin boot dev etc home install lib misc net opt root sbin
selinux srv tftpboot tmp usr var
do
tar -cf - $DIRECTORY | (cd /mnt/to_image; tar -xpvf - )
done
# Skip these directories above and just make them for mounting
mkdir /mnt/to_image/proc
mkdir /mnt/to_image/sys
cd $PUSH_PWD
umount /mnt/from_image
umount /mnt/to_image
grub << EOF
device (hd0) $DEVICE
root (hd0,0)
setup (hd0)
quit
EOF
e2label $PARTITION_1 "/"
mkswap -L "SWAP-hda2" $PARTITION_2
