asterisk users - Oct 2017 - A bit OT - Configure GoIP for Asterisk

I recently received a GoIP-32 for a client project -- primarily outbound 
calling.

How should a GoIP be configured for Asterisk? No fancy shmancy Elastix or 
FPBX GUI -- just using the configuration files.

Single Server Mode, Config By Line, and Trunk Gateway Mode all seem likely 
suspects.

How did you configure your GoIP and why?

What do your relevant sip.conf section(s) look like?

What does your dial command look like?

So far, all I've got out of it is a 503 Declined.

-- 
Thanks in advance,
-------------------------------------------------------------------------
Steve Edwards       sedwards at sedwards.com      Voice: +1-760-468-3867 PST
             https://www.linkedin.com/in/steve-edwards-4244281

On Monday 02 October 2017 at 20:58:33, Steve Edwards wrote:
> I recently received a GoIP-32 for a client project -- primarily outbound
> calling.
> 
> How should a GoIP be configured for Asterisk?
Have you tried http://www.hybertone.com/en/solutionsClass.asp?Id=78


Antony.

-- 
Police have found a cartoonist dead in his house.  They say that details are 
currently sketchy.

                                                   Please reply to the list;
                                                         please *don't* CC
me.

On Mon, 2 Oct 2017, Antony Stone wrote:
> On Monday 02 October 2017 at 20:58:33, Steve Edwards wrote:
>
>> I recently received a GoIP-32 for a client project -- primarily
outbound
>> calling.
>>
>> How should a GoIP be configured for Asterisk?
>
> Have you tried http://www.hybertone.com/en/solutionsClass.asp?Id=78
Thanks, but no joy.

When I first power up the box, 'sip show peers' shows:

 	Name/username Host          Dyn Forcerport Comedia ACL Port Status   
Description
 	goip/goip     (Unspecified) D  Yes        Yes          0    OK (5 ms)

But then a few seconds later it shows:

 	Name/username Host          Dyn Forcerport Comedia ACL Port Status   
Description
 	goip/goip     (Unspecified) D  Yes        Yes          0    UNKNOWN

Every few seconds I get 'empty' SIP debug messages on the console like:

 	<--- SIP read from UDP:192.168.0.51:5087 --->

 	<------------->

Wireshark says they're only 3 bytes long and contain 'SIP'.

When I dial, I get:

     -- Executing [*@newline:6] Dial("SIP/poly-e637-000000cb",
"sip/goip/xxxxxxxxxx") in new stack
       == Everyone is busy/congested at this time (1:0/0/1)

No SIP messages are displayed -- I'm guessing that's a result of the
'status UNKNOWN'.

-- 
Thanks in advance,
-------------------------------------------------------------------------
Steve Edwards       sedwards at sedwards.com      Voice: +1-760-468-3867 PST
             https://www.linkedin.com/in/steve-edwards-4244281