Finally got it worked, the issue was E164 callerid format, where i set it
up, after removing the E164 format its was thru.
Regards
On Fri, Feb 12, 2016 at 9:31 PM Gopalakrishnan N <
gopalakrishnan.an at gmail.com> wrote:
> Now incoming works fine, this is because of my SonicWALL firmware issue,
> tried with different SonicWALL inbound works.
>
> But for outbound am getting 408 request time out error in the NAT on VPN
> tunnel.
>
> On Fri, Feb 12, 2016 at 3:50 AM Gopalakrishnan N <
> gopalakrishnan.an at gmail.com> wrote:
>
>> Hi all,
>>
>> Am using Asterisk 11.2.1. And for site testing, Verizon is doing
Interop
>> testing with site to site IPsec tunnel and with public IP over the
tunnel.
>>
>> Problem is when I do an inbound call, only a IVR message plays, whereas
>> am not able to transfer a call to extension, or dtmf not even works and
>> even outbound getting 408 request timeout.
>>
>> By all means I have configured externaddr and localnet in my sip.conf.
>>
>> Verizon says still the contact information shows my private IP, even
>> though I configured externaddr.
>>
>> When I route the incoming call directly to an hardphone extension, am
not
>> able to answer the call in the hardphone, the ring LED keeps in
blinking
>> even though i pickup the receiver, which is strange i haven;t seen.
>>
>> Can someone had any of this issue or throwing out any information would
>> help me.
>>
>> *Attached PCAP File:*
>> InboundCall_Direct_Extension - not able to answer in the hardphone
>> InboundCall_DTMF - Inbound call plays a message and wait for DTMF,
where
>> its not recognized
>>
>> Tks.
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://lists.digium.com/pipermail/asterisk-users/attachments/20160217/0d4d12b9/attachment.html>