Samsung PABX?
Its TEPRI probably configured in overlap mode so you need to configure
asterisk span that is connected to PABX to overlap mode as well.
When user selects the outside line in overlap mode PABX connects to
asterisk and then sends the digits to it as the user presses the key's.
If overlap mode is not configured in asterisk switch is not started by
asterisk and it just thinks that empty dial string was sent to it.
Just use:
overlapdial=yes
in your zapata.conf
Make sure you have
exten => s,1,Busy()
exten => s,2,Hangup
in your 'samsungincoming' context so that users get a busy signal when
they didn't enter any digits in allotted time otherwise you'll get a
hanging channel in Samsung.
We use that setup with OfficeServ 500 and it works really well.
Regards
-----Original Message-----
From: asterisk-users-bounces@lists.digium.com
[mailto:asterisk-users-bounces@lists.digium.com] On Behalf Of Sahil
Gupta
Sent: Tuesday, 6 June 2006 21:40
To: asterisk-users@lists.digium.com
Subject: [Asterisk-Users] PABX Setup
Hi,
We are trying to port over a PABX to our network. Both PRI's seem to be
live however, whenever someone dials out from the PABX Asterisk happens
to
report :
-- Extension '' in context 'samsungincoming' from
'736327438' does not
exist. Rejecting call on channel 0/31, span 2
If crc4 is turned off, it reports a yellow alarm. Any suggestions?
Regards,
Sahil Gupta
VoiceValley
_______________________________________________
--Bandwidth and Colocation provided by Easynews.com --
Asterisk-Users mailing list
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users