Hi, I've got iaxmodem setup but I'm getting failed fax sending. When I
send a fax it is spooled through the system and I hear the destination
fax machine pick up, it's sat near me, and the transfer starts. However
after about 30 seconds the line drops and the fax machine reports an
error. The faxsend process still thinks it is running and has to be
killed. The logs report
Nov 24 10:50:12.89: [ 8222]: SEND send frame number 132
Nov 24 10:50:12.89: [ 8222]: SEND send frame number 133
Nov 24 10:50:12.89: [ 8222]: MODEM set XON/XOFF/FLUSH: input
interpreted, output disabled
Nov 24 10:50:12.89: [ 8222]: DELAY 200 ms
Nov 24 10:50:13.09: [ 8222]: <-- [11:AT+FTM=146\r]
Nov 24 10:50:13.10: [ 8222]: --> [7:CONNECT]
Nov 24 10:50:13.10: [ 8222]: DELAY 400 ms
Nov 24 10:50:13.50: [ 8222]: <-- data [1025]
Nov 24 10:50:13.50: [ 8222]: <-- data [1027]
Nov 24 10:50:13.50: [ 8222]: <-- data [1029]
Nov 24 10:50:13.50: [ 8222]: <-- data [1029]
Nov 24 10:50:15.02: [ 8222]: <-- data [1029]
Nov 24 10:50:15.02: [ 8222]: <-- data [1033]
Nov 24 10:50:15.02: [ 8222]: <-- data [1034]
Nov 24 10:50:15.02: [ 8222]: <-- data [1031]
Nov 24 10:51:15.01: [ 8222]: MODEM TIMEOUT: writing to modem
Nov 24 10:51:15.01: [ 8222]: MODEM WRITE SHORT: sent 1031, wrote 984
Nov 24 10:51:15.01: [ 8222]: SEND end page
Nov 24 10:51:15.01: [ 8222]: Unspecified Transmit Phase C error
Nov 24 10:51:15.01: [ 8222]: <-- [9:AT+FTH=3\r]
Nov 24 10:51:22.57: [ 8222]: MODEM TIMEOUT: sending HDLC frame
Nov 24 10:51:22.57: [ 8222]: MODEM input buffering enabled
Nov 24 10:51:22.57: [ 8222]: <-- [5:ATH0\r]
Is this an error with my modem or the receiving fax machine?
Regards
Lee
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.digium.com/pipermail/asterisk-users/attachments/20051124/00f58907/attachment.htm