asterisk users - Oct 2005 - Adit 600 and Groundstart

Hey everybody.
 
I have an Adit 600 that I'm not able to get working properly with 
Groundstart.  The Adit (BootCode 1.23), 1 TDM (Version 6.1.2) and 1 FXO 
card (Version 1.12).

The Adit is setup:  ESF,B8ZS. 

1st port is set as signal gs type voice.
2-8 is setup signal ls type voice.

The FXO card is set as follows:

set 1:1 type voice
set 1:1 signal gs

set 1:2-8 type voice
set 1:2-8 signal lscpd

Connection command:

connect a:1:1 1:1
connect a:1:2-8 1:2-8

I've set up the first port in group 1 and the 2nd port in group 2.

I'm able to dial out on group 2(Loopstart) but not on Group 1 (Groundstart).

Putting a phone on the groundstart line and striking ground, I do get 
dial tone.

I've followed the instructions for grounding of the Adit.

Asterisk setup below:

zaptel.conf:

span=1,1,0,esf,b8zs
fxsgs=1
fxsks=2-8
defaultzone=us
loadzone=us

zapata.conf:

[channels]

switchtype = national
context = incoming
signalling = fxs_gs
busydetect = yes
callprogress = no
group = 2
callgroup=1
cancallforward=no
callreturn=no
echotraining=100
echocancelwhenbridged=yes
musiconhold=epi-cd
jitterbuffers=4

channel => 1

; ----------------------------
switchtype = national
context = incoming
signalling = fxs_ks
busydetect = yes
callprogress = no
group = 1
callgroup=1
cancallforward=no
callreturn=no
echotraining=100
echocancelwhenbridged=yes
musiconhold=epi-cd
jitterbuffers=4

channel => 2-8


extensions.conf:

ignorepat=9
exten => _91NXXNXXXXXX,1,NoOP(${EXTEN})
exten => _91NXXNXXXXXX,2,Dial(ZAP/g2/${EXTEN:1})
exten => _91NXXNXXXXXX,3,NoOP(${DIALSTATUS})
exten => _91NXXNXXXXXX,4,Hangup()

Any suggestions will be welcomed.

Thanks!

Doug


-- 
 
Ben Franklin quote:

"Those who would give up Essential Liberty to purchase a little Temporary
Safety, deserve neither Liberty nor Safety."

Doug Lytle wrote:
> Hey everybody.
>
> I have an Adit 600 that I'm not able to get working properly with 
> Groundstart.  The Adit (BootCode 1.23), 1 TDM (Version 6.1.2) and 1 
> FXO card (Version 1.12).
>

For the sake of completeness and the archives, the answer to this 
problem was discovered in the Asterisk 'The Future of Telephony" book.
The zconfig.h file in the zaptel directory needed to be edited and the 
Enable CAC ground start signaling needed to be uncommented.

Doug

-- 
Ben Franklin quote:

"Those who would give up Essential Liberty to purchase a little Temporary
Safety, deserve neither Liberty nor Safety."