asterisk users - Jun 2005 - connecting Asterisk with Siemens HiPath4000

Hi All,

 

Can anyone give me some pointers about what is the requirement at both
sides?

I already have OH323 support in Asterisk, but have no clue how to
configure the HiPath.

 

Thanks,

Ohad

 

-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.digium.com/pipermail/asterisk-users/attachments/20050607/826542fa/attachment.htm

> I already have OH323 support in Asterisk, but have
> no clue how to
> configure the HiPath.
hi...

oh323 is the only thing you need for Astersik. For the
HiPath it depends on which version you have.

FOR HiPath4000 V1.0
-------------------
for version 1.0 you need a HG3550 V1.1 Board.
-Configure the Board using AMO BCSU
Then load the FW into the HG3550. The following steps
are necessary (all via Boot CLI/Console connected to
HG3550 via V.24 interface with a normal Terminal).
-Format Flash
-Load a boot control file
-Load SW Image into flash
-Use the Wizard for the initial setup.
After that the HG3550 is READY and you have to
configure the initial setup using the Routing-Wizard


FOR HiPath4000 V2.0
-------------------
For the v2.0 you need a HG3550 V2.0.Unfortunately
there is no Wizard for the initial setup anymore, so
you have to configure every thing with AMO.

The configuration of the HG3550 is IMHO difficult and
without support from Siemens nearly impossible.

hope it helps...



__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com