I have a TDM400 with an fxo card installed; zaptel.conf is setup for
distinctive ring, but it only partly works:
Our distinctive rings have the same sound in the very first ring (one long
tone). After that, they differ. As a result, all calls produce a dring
signature of 0,0,0.
If I setup the dialplan to immediately hangup, then zaptel hears the next
ring and reports the different signatures correctly.
This is not ideal for three reasons: (a) the caller id is part of the first
ring, so it is lost and (b) it means a lot of rings occur before the phone
is answered and (c) it is inelegant.
Does anyone know of parameters I can set within the zaptel driver or config
files to cause it to wait a little longer before reporting the dring type?
Or any other solution...
Thanks again,
Philip Warner
----------------------------------------------------------------
Philip Warner | __---_____
Albatross Consulting Pty. Ltd. |----/ - \
(A.B.N. 75 008 659 498) | /(@) ______---_
Tel: (+61) 0500 83 82 81 | _________ \
Fax: (+61) 03 5330 3172 | ___________ |
Http://www.rhyme.com.au | / \|
| --________--
PGP key available upon request, | /
and from pgp.mit.edu:11371 |/