Konrads Smelkovs
2005-Feb-18 08:16 UTC
[Asterisk-Users] More on W6692pci NT mode under chan_misdn
So far i've grasped that to use a card in NT mode it should have layermask=3 as module option. Is it the only thing that sets TE or NT mode for card? Perhaps there are settings in misdn.conf ? I can only get the card to work in TE mode and even then when asterisk is ran as asterisk -vvvgc it exits right after chan_misdn is loaded with theese messages: [chan_misdn.so] => (Channel driver for mISDN Support (Bri/Pri)) == Parsing '/etc/asterisk/misdn.conf': Found UnLocking config_mutex == Registered channel type 'mISDN' (This driver enables the asterisk to use hardware which is supported by the new ) debug_init: using stdout for debug log debug_init: using stderr for warning log debug_init: using stderr for error log debug_init: debug_mask = 0 Locking Config Mutex UnLocking Config Mutex Init. Stack on port:1 TE Stack No lower Id port:1 init_stack: Success talkinghead:~ # syslog: Feb 18 16:58:50 talkinghead kernel: MISDN free_device: entitylist not empty in misdn.conf there is [NT cards] context=outgoing ports=1 with ports=1ptp it Segfaults. Clues? -- Konrads Smelkovs Applied IT sorcery.