I am trying to install asterisk@home on a Dell 1650 server. The setup cd runs fine and completes with no errors but when I try to connect to the web site (http:myip/maint) to edit the configs nothing happens just a page not found error. I'm not sure if there is a problem with my dual on board nics but when I check ifconfig I see the dhcp address info that was assigned for eth0 and then underneath some info about a loop back with the address 127.0.0.1. (I can ping the address assined from my other machie but I cannot see the address as leased in my dhcp server) I can successfully change the dhcp address to my own config for eth0 using netconfig but the loop back stuff remains when I use ifconfig to check the ip. Also I can't ever see the ip or config the ip on the second ethernet port. In addition the use of hostnae -i shows an ip of 127.0.0.1. If I use only the ethernet jack 1 and leave the second jack unplugged same result as above, but if I use only jack 2and leave jac 1 unplugged I see just the loopback info and nothing about eth0 with the defined ip and netconfig does nothing. Any help getting this up and runnign would be greatly appreciated. -Jonathan __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around mail.yahoo.com
Jonathan, Log on to asterisk@home with user name :root password: password Then run: netconfig You'll probably find your nic wasn't automatically assigned an IP address. You will need to enter in all of the details manually. Cheers, Dean -----Original Message----- From: asterisk-users-bounces@lists.digium.com [mailto:asterisk-users-bounces@lists.digium.com] On Behalf Of Jonathan Curd Sent: Saturday, January 15, 2005 1:27 AM To: asterisk-users@lists.digium.com Subject: [Asterisk-Users] Asterisk@Home Install Problems I am trying to install asterisk@home on a Dell 1650 server. The setup cd runs fine and completes with no errors but when I try to connect to the web site (http:myip/maint) to edit the configs nothing happens just a page not found error. I'm not sure if there is a problem with my dual on board nics but when I check ifconfig I see the dhcp address info that was assigned for eth0 and then underneath some info about a loop back with the address 127.0.0.1. (I can ping the address assined from my other machie but I cannot see the address as leased in my dhcp server) I can successfully change the dhcp address to my own config for eth0 using netconfig but the loop back stuff remains when I use ifconfig to check the ip. Also I can't ever see the ip or config the ip on the second ethernet port. In addition the use of hostnae -i shows an ip of 127.0.0.1. If I use only the ethernet jack 1 and leave the second jack unplugged same result as above, but if I use only jack 2and leave jac 1 unplugged I see just the loopback info and nothing about eth0 with the defined ip and netconfig does nothing. Any help getting this up and runnign would be greatly appreciated. -Jonathan __________________________________________________ Do You Yahoo!? Tired of spam? Yahoo! Mail has the best spam protection around mail.yahoo.com _______________________________________________ Asterisk-Users mailing list Asterisk-Users@lists.digium.com lists.digium.com/mailman/listinfo/asterisk-users To UNSUBSCRIBE or update options visit: lists.digium.com/mailman/listinfo/asterisk-users