When I start *, and place a call to it from FWD using my laptop and the Pulver communicator on another domain, I get the voice mail messages properly and leave a message ok. I call back again, and the Pulver rings and rings then it goes silent and then hangs up, all the while, asterisk shows to be answering properly and attempts to record a message but nothing is recorded. When attempting to call it again and answer the ringing extension (Zap/4), I can not hear audio from the extension on the FWD or * side. I power cycle the computer and it starts all over again. Any hints? I am running a TDM-400P Card with 1 FXO on channel 1 and 1 FSX interface on channel 4, RH9. The PSTN line is not setup to answer a call. I am new at Linux / * and any help would be appreciated. Thanks. Leo Salas Star~NET Online Systems (903) 785-4192 ext 27 lsalas@1starnet.com IAX: 521496@fwd.pulver.com -------------- next part -------------- An HTML attachment was scrubbed... URL: lists.digium.com/pipermail/asterisk-users/attachments/20041209/e286606b/attachment.htm
What phones, hard, soft, what network topology?
Leo Salas a ?crit :> When I start *, and place a call to it from FWD using my laptop and > the Pulver communicator on another domain, I get the voice mail > messages properly and leave a message ok. I call back again, and the > Pulver rings and rings then it goes silent and then hangs up, all the > while, asterisk shows to be answering properly and attempts to record > a message but nothing is recorded. When attempting to call it again > and answer the ringing extension (Zap/4), I can not hear audio from > the extension on the FWD or * side. I power cycle the computer and it > starts all over again. Any hints? I am running a TDM-400P Card with > 1 FXO on channel 1 and 1 FSX interface on channel 4, RH9. The PSTN > line is not setup to answer a call. I am new at Linux / * and any > help would be appreciated. Thanks. >Add insecure=very in your fwd section of sip.conf -- Daniel