SBC installed a T1 ADTSe (Digital Trunking Service Enhanced) e&m wink start with 24 1 way trunks. The CO says they dial pulse DP the seven digit dnis number. The channels work now but take long time to answer and get these messages repeating until I guess the CO stops Pulse dialing the number. Nov 23 19:08:58 WARNING[1827865]: chan_zap.c:4718 ss_thread: getdtmf on channel 8: Operation now in progress -- Hungup 'Zap/8-1' -- Starting simple switch on 'Zap/8-1' Nov 23 19:08:59 WARNING[1828889]: chan_zap.c:4718 ss_thread: getdtmf on channel 8: Operation now in progress -- Hungup 'Zap/8-1' -- Starting simple switch on 'Zap/8-1' Nov 23 19:09:00 WARNING[1829913]: chan_zap.c:4718 ss_thread: getdtmf on channel 8: Operation now in progress -- Hungup 'Zap/8-1' -- Starting simple switch on 'Zap/8-1' Nov 23 19:09:01 WARNING[1830937]: chan_zap.c:4718 ss_thread: getdtmf on channel 8: Operation now in progress -- Hungup 'Zap/8-1' -- Starting simple switch on 'Zap/8-1' Nov 23 19:09:02 WARNING[1831961]: chan_zap.c:4718 ss_thread: getdtmf on channel 8: Operation now in progress -- Hungup 'Zap/8-1' -- Starting simple switch on 'Zap/8-1' Nov 23 19:09:03 WARNING[1832985]: chan_zap.c:4718 ss_thread: getdtmf on channel 8: Operation now in progress -- Hungup 'Zap/8-1' -- Starting simple switch on 'Zap/8-1' Nov 23 19:09:04 WARNING[1834009]: chan_zap.c:4718 ss_thread: getdtmf on channel 8: Operation now in progress -- Hungup 'Zap/8-1' If I set pulsedial=yes will asterisk interpret these DP signals. Thanks