I'm having problems getting a TDM11B (green FXS module in slot 1 and the
red FXO card in slot 4) to configure at boot time. zaptool and ztcfg all
indicate that the card is working fine and with no errors, but the log
file has the following messages:
Nov 1 14:14:54 asterisk kernel: Zapata Telephony Interface Registered on
major 196
Nov 1 14:14:54 asterisk kernel: Specify address with base=0xNNNNN
Nov 1 14:14:54 asterisk kernel: Registered Tormenta2 PCI
Nov 1 14:14:54 asterisk kernel: PCI: Enabling device 01:03.0 (0004 ->
0007)
Nov 1 14:14:54 asterisk kernel: Freshmaker version: 71
Nov 1 14:14:54 asterisk kernel: Freshmaker passed register test
Nov 1 14:14:54 asterisk kernel: Timeout waiting for calibration of module 0
Nov 1 14:14:54 asterisk kernel: Timeout waiting for calibration of module 0
Nov 1 14:14:54 asterisk kernel: Proslic Failed on Second Attempt to Auto
Calibr
Nov 1 14:14:54 asterisk kernel: Module 0: Installed -- MANUAL FXS
Nov 1 14:14:54 asterisk kernel: Module 1: Not installed
Nov 1 14:14:54 asterisk kernel: Module 2: Not installed
Nov 1 14:14:54 asterisk kernel: Module 3: Installed -- AUTO FXO (FCC mode)
Nov 1 14:14:54 asterisk kernel: Found a Wildcard TDM: Wildcard TDM400P REV
E/F (4 modules)
Nov 1 14:14:54 asterisk kernel: usb.c: registered new driver wcusb
Nov 1 14:14:54 asterisk kernel: Wildcard USB FXS Interface driver
registered
Nov 1 14:14:54 asterisk kernel: Registered tone zone 0 (United States /
North America)
The autoconfig of the FXS module isn't working and a spurious USB FXS
interface driver gets registered for some reason (though zaptool doesn't
show it).
While I can get a phone set to ring on the FXO port and the simple
switch starts up when it goes off-hook, I don't get dial-tone and cannot
dial out.
I've checked out the power cable it's using and it seems to be fine
(11.97 v and 5.1v)
Anyone have any ideas on why it wouldn't auto configure, or how I can
manually configure it?
Stephen