Abdelghani Khaled
2004-Oct-31 04:04 UTC
[Asterisk-Users] Can't install the mfcr2 support correctly
Hi Mr Jack, hi everybody Thank you for your answer for my message titled "can't run ztcfg". I tried what you proposed me and the error I told about is not signaled. However I still have problems to get mfc/r2 support running. I refered to the mfcr2 support documentation available in the opencall.org website http://www.opencall.org/installing-mfcr2.html . The digium card I have is the TE410P After installing the zaptel driver using the following commands: make clean make install make config After adding the necessary lines to the zaptel.conf file. The problem is that when I execute the following command : modprobe wct4xxp which is necessary to run ztcfg correctly (as you told me) I get the 4 ports lights of the card off. Yesterday I got them red. And when I connect an E1 to a port I don't get a green light but I get either a red light (or no light at all) if the light was already red or no light if the light was already off. I hope that my message is clear and that someone will help me. _________________________________________________________________ MSN Hotmail : antivirus et antispam int?gr?s http://www.msn.fr/newhotmail/Default.asp?Ath=f
Dear Khaled, I thing you must read the documentation a little bit more deapely! does zaptel compile ok ? which kernel are you using ? have you configure the zaptel.conf file which parameters are you using for r2 signaling ? refer to this page as guide for starting http://www.asterisk.org/index.php?menu=download read the all page no lights aster wct4xxp means span is not configured! good luck ! Jack ----- Original Message ----- From: "Abdelghani Khaled" <ghani_khaled@hotmail.com> To: <fox@mobileemail.vodafone.it> Cc: <pbx@itcee.be> Sent: Sunday, October 31, 2004 12:04 PM Subject: [Asterisk-Users] Can't install the mfcr2 support correctly> Hi Mr Jack, hi everybody > > Thank you for your answer for my message titled "can't run ztcfg". I tried > what you proposed me and the error I told about is not signaled. However I > still have problems to get mfc/r2 support running. > > I refered to the mfcr2 support documentation available in the opencall.org > website http://www.opencall.org/installing-mfcr2.html . > > The digium card I have is the TE410P > > After installing the zaptel driver using the following commands: > > make clean > make install > make config > > After adding the necessary lines to the zaptel.conf file. > > The problem is that when I execute the following command : > > modprobe wct4xxp > > which is necessary to run ztcfg correctly (as you told me) I get the 4 > ports lights of the card off. > Yesterday I got them red. > > And when I connect an E1 to a port I don't get a green light but I get > either a red light (or no light at all) if the light was already red or no > light if the light was already off. > > I hope that my message is clear and that someone will help me. > > _________________________________________________________________ > MSN Hotmail : antivirus et antispam int?gr?s > http://www.msn.fr/newhotmail/Default.asp?Ath=f > > _______________________________________________ > Asterisk-Users mailing list > Asterisk-Users@lists.digium.com > http://lists.digium.com/mailman/listinfo/asterisk-users > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-users