asterisk users - Oct 2004 - TDM400P hardware problems

Dear All,

I am using TDM400P card for about 4 months right now with
4 FXO modules.
During this 4 months of use I needed to shutdown server (power off) becuase
the card just stopped working.
The card did not picked up calls, on console there is nothing.
Shutting down asterisk does not help or loding drivers again.
The server has to be powerd off and then turned on again.

Could it be hardware (TDM400P) problem ?
Did somebody notice the same problems ?

Bartosz

----- Original Message ----- 
From: "Bartosz Jozwiak" <bartek@cq-link.sr>
To: <asterisk-users@lists.digium.com>
Sent: Thursday, October 28, 2004 10:55 AM
Subject: [Asterisk-Users] TDM400P hardware problems


| Dear All,
| 
| I am using TDM400P card for about 4 months right now with
| 4 FXO modules.
| During this 4 months of use I needed to shutdown server (power off) becuase
| the card just stopped working.
| The card did not picked up calls, on console there is nothing.
| Shutting down asterisk does not help or loding drivers again.
| The server has to be powerd off and then turned on again.
| 
| Could it be hardware (TDM400P) problem ?
| Did somebody notice the same problems ?
| 
| Bartosz
| _______________________________________________

I was just going to ask if this has been fixed yet.... 

I have the exact same card, hasn't worked properly yet (with
respect to the reboot situation).

the same behaviour happens with zaptel channels configured or not

what version of the zaptel drivers are you using?  
Greg

> On Thu, 2004-10-28 at 14:21, Bartosz Jozwiak wrote:
> > It is possible to check if I have "REV H" TDM400P card
without
> > opening and stopping server ?
> 
> cat /proc/zaptel/*
> 
 Looks like have good card WCTDM/0 "Wildcard TDM400P REV E/F Board 1"
but still having these problem ( once in a while )

Bartosz