asterisk users - Oct 2004 - Using AVM C4 with fewer than four lines?

Dear list,

We have an * setup with an AVM C4 that works very well.  There is one
annoying problem though.  Since we only have two ISDN lines at the moment,
only two are connection to the C4.  But the C4 reports 8 working B-channels
to *.  This means that on dialing out, you will be randomly assigned 
either a
connected or unconnected port (luckily it doesn't affect incoming calls).

Does anyone know of a way to disable the ports on the C4 that are not 
connected?

regards
Louis

Hi,

On Thu, 28 Oct 2004 at 12:16, Louis van Dompselaar wrote:
> Does anyone know of a way to disable the ports on the C4 that are
> not connected?
I think changing devices=4 to devices=2 in capi.conf should do the
trick. Of course you have to make sure that your ISDN lines are
connected to the two ports that haven't been disabled.

cu
	Reinhard