asterisk users - Oct 2004 - T100P to Verizon Smart Jack Question

Has anybody had any experience connecting the t100p to 
a verizon smart jack.

I've been told the t100p uses an RJ48 but not the revision
(i.e. C, S, X )

I've created wires (RJ48C x-over) but no green light on the t100p
1-4
2-5
4-1
5-2

i've created wire (RJ48S)  no green light
(only because the HyperEdge Smart Jack says this is default 
but can't confirm this to be true in my case).
1-7
2-8
7-1
8-2

Standard RJ45 ether cable gets ligts on the card and smart jack
but no signal

zttool indicates OK for both the t100p and the tdm04b cards (no alarms)
I can ping the t100p but no further with the standard ether cable

I'm at a loss


Regards
Greg Cirino

On Mon, 2004-10-11 at 11:45 -0400, Cirelle Enterprises
wrote:
> Has anybody had any experience connecting the t100p to 
> a verizon smart jack.
> 
> I've been told the t100p uses an RJ48 but not the revision
> (i.e. C, S, X )
> 
> I've created wires (RJ48C x-over) but no green light on the t100p
> i've created wire (RJ48S)  no green light
> (only because the HyperEdge Smart Jack says this is default 
> but can't confirm this to be true in my case).
> Standard RJ45 ether cable gets ligts on the card and smart jack
> but no signal
Then you should have noticed then that no cross over cable is necessary
to a smart jack. Only time to use a cross over cable is when connecting
2 end devices together.
> zttool indicates OK for both the t100p and the tdm04b cards (no alarms)
> I can ping the t100p but no further with the standard ether cable
Are you doing data or voice on the T100P? 
-- 
Steven Critchfield <critch@basesys.com>

----- Original Message ----- 
From: "Steven Critchfield" <critch@basesys.com>
To: "Asterisk Users Mailing List - Non-Commercial Discussion"
<asterisk-users@lists.digium.com>
Sent: Monday, October 11, 2004 2:02 PM
Subject: Re: [Asterisk-Users] T100P to Verizon Smart Jack Question
<snip>
| 
| Are you doing data or voice on the T100P? 
| -- 


both is the goal , but for the moment just trying to get the routing working

Greg