Im new to asterisk and telephony in general...so any help would be greatly appreciated I have asterisk system running on a T1 PRI using a T100P. As far as I can tell all the .conf files are correct but every 10 seconds I get the following: ------------Begin Debug------------------- T203 counter expired, sending RR and scheduling T203 again Sending Receiver Ready (46) > [ 00 01 01 5d ] > Supervisory frame: > SAPI: 00 C/R: 0 EA: 0 > TEI: 000 EA: 1 > Zero: 0 S: 0 01: 1 [ RR (receive ready) ] > N(R): 046 P/F: 1 > 0 bytes of data -- Restarting T203 counter < [ 00 01 01 5d ] < Supervisory frame: < SAPI: 00 C/R: 0 EA: 0 < TEI: 000 EA: 1 < Zero: 0 S: 0 01: 1 [ RR (receive ready) ] < N(R): 046 P/F: 1 < 0 bytes of data -- ACKing all packets from 45 to (but not including) 46 -- Since there was nothing left, stopping T200 counter -- Stopping T203 counter since we got an ACK -- Nothing left, starting T203 counter -- Got RR response to our frame -- Restarting T203 counter --------------End Debug------------------- it only shows up in the console when I turn on intense debuging for the span and set verbose to at least 4. The PRI is showing green, but when you try to call in it just gives a fast busy and asterisk doesnt show anything as having happened... -- *G. Phileomonto*
Im new to asterisk and telephony in general...so any help would be greatly appreciated I have asterisk system running on a T1 PRI using a T100P. As far as I can tell all the .conf files are correct but every 10 seconds I get the following: ------------Begin Debug------------------- T203 counter expired, sending RR and scheduling T203 again Sending Receiver Ready (46) > [ 00 01 01 5d ] > Supervisory frame: > SAPI: 00 C/R: 0 EA: 0 > TEI: 000 EA: 1 > Zero: 0 S: 0 01: 1 [ RR (receive ready) ] > N(R): 046 P/F: 1 > 0 bytes of data -- Restarting T203 counter < [ 00 01 01 5d ] < Supervisory frame: < SAPI: 00 C/R: 0 EA: 0 < TEI: 000 EA: 1 < Zero: 0 S: 0 01: 1 [ RR (receive ready) ] < N(R): 046 P/F: 1 < 0 bytes of data -- ACKing all packets from 45 to (but not including) 46 -- Since there was nothing left, stopping T200 counter -- Stopping T203 counter since we got an ACK -- Nothing left, starting T203 counter -- Got RR response to our frame -- Restarting T203 counter --------------End Debug------------------- it only shows up in the console when I turn on intense debuging for the span and set verbose to at least 4. The PRI is showing green, but when you try to call in it just gives a fast busy and asterisk doesnt show anything as having happened... -- *G. Phileomonto*