asterisk users - May 2004 - CDR destination when user presses '#'

If '#' is pressed during a call the CDR that is written at the end of 
the call contains '#' in the dst / destination field rather than the 
number that was originally called.  How do I avoid losing that original 
number so that I can use the CDR for billing?

I've tried not having a '#' target in extensions.conf and I've
tried
calling ResetCDR(w) in the '#' target hoping that would cause a CDR to 
be written with the original number but in both cases the CDR still 
contains '#'.

Any ideas please?

Thanks,

Mark.

Mark Turner wrote:
> If '#' is pressed during a call the CDR that is written at the end
of
> the call contains '#' in the dst / destination field rather than
the
> number that was originally called.  How do I avoid losing that original 
> number so that I can use the CDR for billing?
> 
> I've tried not having a '#' target in extensions.conf and
I've tried
> calling ResetCDR(w) in the '#' target hoping that would cause a CDR
to
> be written with the original number but in both cases the CDR still 
> contains '#'.
> 
> Any ideas please?
> 
> Thanks,
> 
> Mark.
Mark,

I'm not sure if this helps, but I have experienced the same problem with 
the special 'h', 't', 'T', etc. extensions.  I worked
around the problem
by saving the the original extension in a variable, then restoring it 
using a Goto back to the original extension.

Perhaps something like this will work for you (I have not tested this):

exten => 5551212,1,SetVar(ORIG_EXTEN=${EXTEN})
exten => 5551212,2,Dial(Zap/5559999)
exten => 5551212,3,Hangup

exten => #,1,Goto(${ORIG_EXTEN},3)

Regards,
../fam
-- 
Frank A. Mandarino                           fmandarino@spindrift.on.ca
Spindrift Management, Toronto
416 642-3404