Alex Lopez
2003-Jul-24 21:46 UTC
[Asterisk-Users] INFO: How the T410P sets the number of channels per span
After speaking with Martin @ Digium, I have the following answers. The driver Wct4xxp determines the number of channels by the signaling type set in the /etc/zaptel.conf file. For example if all the spans used b8zs,esf your spans would look like this: Span 1 Zap/1 - Zap/24 Span 2 Zap/25 - Zap/48 Span 3 Zap/49 - Zap/72 Span 4 Zap/73 - Zap/96 However if you have an E1 intermixed say on span 2 you channels would be: Span 1 Zap/1 - Zap/24 Span 2 Zap/25 - Zap/54 This is because the signaling s\is set to E1 Span 3 Zap/55 - Zap/78 Span 4 Zap/79 - Zap/102 So it is the driver that sets up the devices in the /dev/Zap directory, This could be a gotcha for newbies as the channels are all contiguous and the span separations are on numbers other than the standard 24 or 30. Of Course this is just an example and in a real life situation you would probable start with an E1 or end with an E1 instead of putting it smack dab in the middle. I hope the this helps..... Message: 2 Date: Thu, 24 Jul 2003 01:07:54 -0400 From: "Alex Lopez" <alex@opsys.com> To: <asterisk-users@lists.digium.com> Subject: [Asterisk-Users] T410P and zaptel.conf Reply-To: asterisk-users@lists.digium.com One a t400p I know that I have 24 channels per port for a total of 96. However the T410 card allows for E1 as well as T1 lines. How does it determine how many channels per port. For a more specific question. Would the first Zap device on the second port be Zap/25 or Zap/30 when using a T1?? I looked for docs on this but found nothing.. =20 Other questions: Is the electrical interface the same for a E1 as a T1?? How does the card know which is which? Is it by the span def in the /etc/zaptel.conf file? Has anyone seen a technical document on this card???