Hi guys, First I would like to thank all the guys involved with traffic shaping on Linux. I have been using it since mid 2001. I first started with CBQ using cbq-init.v6.2. This got my attention and started to test it. The results were not that accurate. I then started to see if I could figure it out for myself by doing it manually but what a nightmare. As you guy''s know the doc''s are vapourware! I got a lot of help from the Adv networking HOWTO and Stef Coene but it still was painful. Then along came HTB!!! I can''t tell you how it changed my life. Thanks devik!!!! you are a star. I hope your htb get into the mainstream kernel. I run an ISP and in South Africa where the cost of comms is very expensive and htb is a life saver. The market is very cut-throat as well. The likes of Packeteer Sitara and Cache-flow or even Cisco are ( with our currency in the third world doldrums ) not an option!!! So now I have HTB and with a few lines of code ( Plus the help of Squid ) I can beat the above mentioned products. What I would like to know is would anyone like to sponsor a GUI to set up HTB. As I have gotten 80% thru the project, and as times are tough in SA any help would be appreciated. There is a HUGE resistance to Linux here. SA is MAD on MS and brand names like Cacheflow et al. My thinking was that a Web based front end to the product would hide the apparent complexities of Linux/tc/htb etc. So I wrote a perl script and dot/graphviz output, thanks to the stuff from Stef Coene and have almost finished it! Once again Thanks all! Regards Allan Gee Equation www.equation.co.za 021 4181777