On Tuesday 28 December 2004 18:46, Patrich Björklund
wrote:> Hi all! I''m new to this list, and hope for some clarity in this
matter:
>
> I have a home-gateway with linux-2.6.9 and iproute2 (ver:2.6.9). My
> following tc syntaxes.
>
> # eth0 internet scheduleing are:
>
> tc qdisc add dev eth0 root handle 1: htb default 20
>
> tc class add dev eth0 parent 1: classid 1:1 htb rate 512kbit burst 6k
> tc class add dev eth0 parent 1:1 classid 1:10 htb rate 512kbit burst 6k
> prio 1
> tc class add dev eth0 parent 1:1 classid 1:20 htb reate 9*512/10kbit
> burst 6k prio 2
>
> tc qdisc add dev eth0 parent 1:10 handle 10: sfq perturb 10
> tc qdisc add dev eth0 parent 1:20 handle 20: sfq perturb 10
>
> tc filter add dev eth0 parent 1:0 protocol ip prio 10 u32 match ip tos
> 0x10 0xff flowid 1:10
> tc filter add dev eth0 parent 1: protocol ip prio 10 u32 \
> match ip protocol 6 0xff \
> match u8 0x50 0x0f at 0 \
> match u16 0x0000 0xffc0 at 2 \
> match u8 0x10 0xff at 33 \
> flowid 1:10
>
> tc qdisc add dev dev eth0 handle ffff: ingress
>
> tc filter add dev eth0 parent ffff: protocol ip prio 50 u32 \
> match ip src 0.0.0.0/0 police rate 2200kbit burst 10k drop flowid :1
>
> # My eth1 schedule:
> tc qdisc add dev eth1 root tbf rate 512kbit latency 50ms burst 10000
>
> The long eth0 tc-script is fetched externally as you may see...but:
>
> This have worked well for me (no, really) but...since I am a newbee, I
> have read the lartc doc, and understood some but very much was really
> hard to get...especially the class and filter stuff. Lets say it''s
not a
> ''for dummies'' book :) No complainig. My Q are, is there a
chance I will
> get packet losses or other messes to gateway(eth1/eth0) if I have no
> rule set for my LAN-PC:s? Or the above scripts for that matter...Should
> I have a ''eth1 tc-command here?'' Or any advice or comment
would be
> greatly appreciated.
There are no real errors in your script. Of course, each script can be tuned.
Some remarks:
- you are only shaping traffic leaving eth0, if you add class/filters to eth1,
you can also shaping traffic leaving eth1
- you are shaping traffic leaving eth1 because you are shaping traffic
entering eth0 with the ingress qdisc. but using htb/cbq for shaping gives
you much more control.
- try http://docum.org/ for other/more information.
Stef
_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/