Hello.
Casey asked for the right additional data. Additional output of the
following commands might help as well:
xm list
brctl show
Double check you are plugging your cable modem to the right
interface/network/VLAN.
El 06/05/13 15:19, jacek burghardt escribió:> I had made an attempt to install pfsense under xen. The biggest issue
> I had run is that if i bridge network interface that has cable modem
> there is no way for virtual interface to obtain ip address. I wonder
> what am I doing wrong?
If your modem is set into bridged mode, some ISP''s requires you to
clone
it''s MAC address on the client device, that is the VM.
Not sure about dhcp client functionality, but it''s known the dhcp
server
does not works well unless you disable offload capability on your
virtualized network card, within DomU:
"ethtool -K ETHDEV tx off" usually is enough.
Try to sniff your bridge using tcpdump on Dom0, to see what goes wrong
on the DHCP negotiation.
Greetings.
--
Alexandre Kouznetsov