Hi.
I'm running the 9.1-RC1 release.
At the end of the boot sequence, I see:
mps0: mpssas_scsiio_timeout checking sc 0xffffff8000759000 cm
0xffffff8000784380
(probe19:mps0:0:19:0): TEST UNIT READY. CDB: 0 0 0 0 0 0 length 0 SMID
240 command timeout cm 0xffffff8000784380 ccb 0xfffffe0006918000
mps0: mpssas_alloc_tm freezing simq
mps0: timedout cm 0xffffff8000784380 allocated tm 0xffffff8000771148
(probe19:mps0:0:19:0): TEST UNIT READY. CDB: 0 0 0 0 0 0 length 0 SMID
240 completed timedout cm 0xffffff8000784380 ccb 0xfffffe0006918000
during recovery ioc 8048 scsi 0 state c xfer 0
(noperiph:mps0:0:19:0): SMID 1 abort TaskMID 240 status 0x0 code 0x0 count 1
(noperiph:mps0:0:19:0): SMID 1 finished recovery after aborting TaskMID 240
mps0: mpssas_free_tm releasing simq
(I had a similar error with a hang in 9.0 -- couldn't get out of it ..
at least under 9.1 it doesn't hang).
... Can someone help me to figure out what this means? Should I be alarmed?
The system has an Intel S3000AH server board with an LSI 9211-8i card
with SAS2008 chipset, running IT firmware. It is connected to an
older Chenbro CK12803 expander card which is connected to the 16 disk
ports in the AIC RMC3E2-XPSS 3U chassis. The disks are all recognized
-- da0 is a 1 TB, da1-11 are 2 TB disks.
Any ideas?
Thanks ..
Jason Keltz
