Dear List Members
I have recently installed 8 STABLE and built my custom kernel, but still
getting these in my pciconf list
none0@pci0:0:3:0: class=0x078000 card=0x02761028 chip=0x2e148086
rev=0x03 hdr=0x00
vendor = 'Intel Corporation'
device = 'Intel Active Client Manager HECI Device
(PCIVEN_8086&DEV_2E14&SUBSYS_3035103C&REV_03B1B68)'
class = simple comms
none1@pci0:0:3:3: class=0x070002 card=0x02761028 chip=0x2e178086
rev=0x03 hdr=0x00
vendor = 'Intel Corporation'
device = 'Intel PCI Serial Port (CC_0700)'
class = simple comms
subclass = UART
I have
device uart # Generic UART driver
in my custom kernel, so I would expect uart devices to be detected and
usable -- however, they are not.
Also, even though I have custom keyboard in my kernel configuration,
whenever I boot into single user mode I get US layout (it works fine
when in multi-user mode).
I am using a Dell Optiplex 960 series machine.
I have googled as much as I can, and also visited the intel website for
further information -- no luck so far. Any pointer to possible solution
is highly appreciated
Thanks
On Wed, Jun 30, 2010 at 01:16:34PM +0100, Free BSD wrote:> Dear List Members > > I have recently installed 8 STABLE and built my custom kernel, but > still getting these in my pciconf list > > none0@pci0:0:3:0: class=0x078000 card=0x02761028 > chip=0x2e148086 rev=0x03 hdr=0x00 > vendor = 'Intel Corporation' > device = 'Intel Active Client Manager HECI Device > (PCIVEN_8086&DEV_2E14&SUBSYS_3035103C&REV_03B1B68)' > class = simple comms > > > none1@pci0:0:3:3: class=0x070002 card=0x02761028 > chip=0x2e178086 rev=0x03 hdr=0x00 > vendor = 'Intel Corporation' > device = 'Intel PCI Serial Port (CC_0700)' > class = simple comms > subclass = UART > > > I have > device uart # Generic UART driver > in my custom kernel, so I would expect uart devices to be detected > and usable -- however, they are not.Are you including "device puc" in your device list? puc connects PCI-based serial/parallel devices to uart/sio and ppc. Please see the uart(4) man page.> Also, even though I have custom keyboard in my kernel configuration, > whenever I boot into single user mode I get US layout (it works fine > when in multi-user mode).This is probably normal. -- | Jeremy Chadwick jdc@parodius.com | | Parodius Networking http://www.parodius.com/ | | UNIX Systems Administrator Mountain View, CA, USA | | Making life hard for others since 1977. PGP: 4BD6C0CB |
On Wed, Jun 30, 2010 at 1:16 PM, Free BSD <freebsd@vfemail.net> wrote:> Dear List Members > Also, even though I have custom keyboard in my kernel configuration, > whenever I boot into single user mode I get US layout (it works fine when in > multi-user mode).Does it work correctly if you run kbdmap and choose the correct layout? If so, set keymap in /etc/rc.conf so it is always configured correctly. Cheers Tom