Hi all,
Just upgraded my little mini-ITX server from 4.9p4 to 4.10p2. The new
kernel booted single-user fine before I did the installworld, but panics
when bringing up my aue0 interface during multi-user boot. aue0 is my
'outside' interface which I didn't need during installworld,
otherwise I
might have caught this earlier. The kernel is GENERIC + ipfilter.
I've attached a DDB stack trace and dmesg.boot from the old 4.9 kernel that
fortunately still works. Unfortunately I don't seem to be able to get a
crash dump - if I try I just get a few hundred repetitions of:
panic: uhci_abort_xfer: not in process context
Uptime: 18s
then the machine reboots. There's also some whining about miibus
immediately before the crash:
module_register: module miibus/ukphy already exists!
linker_file_sysinit "miibus.ko" failed to register! 17
This didn't happen before, so it's probably significant.
This looks like it's happening deep inside the USB stack, so I guess
it's
related to the USB mega-MFC before the 4.10 release. I'm not at all
familiar with the guts of our USB so I'm not sure where to start debugging
this... I'd also rather not have to crash my server too many more times to
figure out what's going on here.
Any ideas?
Many thanks in advance,
Scott
--
==========================================================================Scott
Mitchell | PGP Key ID | "Eagles may soar, but weasels
Cambridge, England | 0x54B171B9 | don't get sucked into jet
engines"
scott at fishballoon.org | 0xAA775B8B | -- Anon
-------------- next part --------------
Automatic boot in progress...
/dev/ad0s1a: FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s1a: clean, 21432 free (376 frags, 2632 blocks, 0.6% fragmentation)
/dev/ad0s1g: FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s1g: clean, 20431499 free (8363 frags, 2552892 blocks, 0.0%
fragmentation)
/dev/ad0s1f: FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s1f: clean, 307946 free (11362 frags, 37073 blocks, 2.2% fragmentation)
/dev/ad0s1e: FILESYSTEM CLEAN; SKIPPING CHECKS
/dev/ad0s1e: clean, 483015 free (551 frags, 60308 blocks, 0.1% fragmentation)
Doing initial network setup: hostname ipmon ipfilter ipnat0 entries flushed from
NAT table
0 entries flushed from NAT list
domain.
module_register: module miibus/ukphy already exists!
linker_file_sysinit "miibus.ko" failed to register! 17
Fatal trap 12: page fault while in kernel mode
fault virtual address = 0x70
fault code = supervisor read, page not present
instruction pointer = 0x8:0xc0242d20
stack pointer = 0x10:0xc044ff74
frame pointer = 0x10:0xc044ff98
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = Idle
interrupt mask = net tty bio cam
kernel: type 12 trap, code=0
Stopped at tsleep+0x74: cmpl $0,0x70(%ebx)
db> tr
tsleep(c20b3f00,10,c0431b18,0) at tsleep+0x74
usbd_transfer(c20b3f00,c044fff4,c036f10d,c20b3f00,0) at usbd_transfer+0x127
usbd_sync_transfer(c20b3f00,0,c1df5200,1,c03b784c) at usbd_sync_transfer+0x10
usbd_do_request_flags_pipe(c1ecc000,c1ed7f80,c045004c,c0450064,0) at
usbd_do_request_flags_pipe+0x61
usbd_do_request_flags(c1ecc000,c045004c,c0450064,0,0) at
usbd_do_request_flags+0x20
usbd_do_request(c1ecc000,c045004c,c0450064,f140,10025) at usbd_do_request+0x1a
aue_csr_write_1(c1df5200,25,0,1,0) at aue_csr_write_1+0x6c
aue_miibus_readreg(c1ed7f00,0,1,c04500a4,c01f6117) at aue_miibus_readreg+0x35
MIIBUS_READREG(c1ed7f00,0,1,c1ed7e80,c1e00720) at MIIBUS_READREG+0x34
miibus_readreg(c1ed7e80,0,1,c04500d8,c01f68fd) at miibus_readreg+0x1b
MIIBUS_READREG(c1ed7e80,0,1,c1ecba00,c1ecba40) at MIIBUS_READREG+0x34
ukphy_service(c1ecba00,c1ecba40,1) at ukphy_service+0x121
mii_tick(c1ecba40) at mii_tick+0x19
aue_tick(c1df5200,400000,0,0,ffffffff) at aue_tick+0x26
softclock(0,10,10,10,ffffffff) at softclock+0xd1
doreti_swi(7,673,1,803035,0) at doreti_swi+0xf
idle_loop() at idle_loop+0x1d
db>
-------------- next part --------------
Copyright (c) 1992-2003 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 4.9-RELEASE-p4 #0: Tue Mar 23 21:27:51 GMT 2004
scott@tuatara.fishballoon.org:/local/obj/local/-SECURITY/src/sys/LLAMA
Timecounter "i8254" frequency 1193182 Hz
CPU: VIA C3 Samuel 2 (599.71-MHz 686-class CPU)
Origin = "CentaurHauls" Id = 0x673 Stepping = 3
Features=0x803035<FPU,DE,TSC,MSR,MTRR,PGE,MMX>
real memory = 503316480 (491520K bytes)
avail memory = 484147200 (472800K bytes)
Preloaded elf kernel "kernel.old" at 0xc0563000.
md0: Malloc disk
Using $PIR table, 5 entries at 0xc00fded0
apm0: <APM BIOS> on motherboard
apm0: found APM BIOS v1.2, connected at v1.2
npx0: <math processor> on motherboard
npx0: INT 16 interface
pcib0: <Host to PCI bridge> on motherboard
pci0: <PCI bus> on pcib0
agp0: <VIA Generic host to PCI bridge> mem 0xd0000000-0xd7ffffff at device
0.0 on pci0
pcib1: <PCI to PCI bridge (vendor=1106 device=b091)> at device 1.0 on pci0
pci1: <PCI bus> on pcib1
pci1: <VGA-compatible display device> at 0.0 irq 11
fwohci0: <VIA VT6306> port 0xc000-0xc07f mem 0xde000000-0xde0007ff irq 10
at device 13.0 on pci0
fwohci0: OHCI version 1.0 (ROM=1)
fwohci0: No. of Isochronous channel is 4.
fwohci0: EUI64 00:40:63:00:00:02:95:7e
fwohci0: Phy 1394a available S400, 2 ports.
fwohci0: Link S400, max_rec 2048 bytes.
firewire0: <IEEE1394(FireWire) bus> on fwohci0
if_fwe0: <Ethernet over FireWire> on firewire0
if_fwe0: Fake Ethernet address: 02:40:63:02:95:7e
sbp0: <SBP2/SCSI over firewire> on firewire0
fwohci0: Initiate bus reset
fwohci0: BUS reset
fwohci0: node_id=0xc800ffc0, gen=1, CYCLEMASTER mode
firewire0: 1 nodes, maxhop <= 0, cable IRM = 0 (me)
firewire0: bus manager 0 (me)
uhci0: <VIA 83C572 USB controller> port 0xc400-0xc41f irq 11 at device
16.0 on pci0
usb0: <VIA 83C572 USB controller> on uhci0
usb0: USB revision 1.0
uhub0: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
aue0: LINKSYS Inc. LINKSYS USB Adapter, rev 1.10/1.01, addr 2
aue0: Ethernet address: 00:04:5a:07:c6:86
miibus0: <MII bus> on aue0
ukphy0: <Generic IEEE 802.3u media interface> on miibus0
ukphy0: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
uhci1: <VIA 83C572 USB controller> port 0xc800-0xc81f irq 10 at device
16.1 on pci0
usb1: <VIA 83C572 USB controller> on uhci1
usb1: USB revision 1.0
uhub1: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub1: 2 ports with 2 removable, self powered
uhci2: <VIA 83C572 USB controller> port 0xcc00-0xcc1f irq 12 at device
16.2 on pci0
usb2: <VIA 83C572 USB controller> on uhci2
usb2: USB revision 1.0
uhub2: VIA UHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub2: 2 ports with 2 removable, self powered
pci0: <USB controller> at 16.3 irq 5
isab0: <PCI to ISA bridge (vendor=1106 device=3177)> at device 17.0 on
pci0
isa0: <ISA bus> on isab0
atapci0: <VIA 8235 ATA133 controller> port 0xd000-0xd00f at device 17.1 on
pci0
ata0: at 0x1f0 irq 14 on atapci0
ata1: at 0x170 irq 15 on atapci0
pci0: <unknown card> (vendor=0x1106, dev=0x3059) at 17.5 irq 12
vr0: <VIA VT6102 Rhine II 10/100BaseTX> port 0xdc00-0xdcff mem
0xde002000-0xde0020ff irq 11 at device 18.0 on pci0
vr0: Ethernet address: 00:40:63:c5:8d:63
miibus1: <MII bus> on vr0
ukphy1: <Generic IEEE 802.3u media interface> on miibus1
ukphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, auto
wi0: <PRISM2STA WaveLAN> port 0xe400-0xe43f,0xe000-0xe07f mem
0xde003000-0xde003fff irq 10 at device 20.0 on pci0
wi0: 802.11 address: 00:04:e2:0e:36:b0
wi0: using RF:PRISM2 MAC:HFA3841 CARD:HWB3163 rev.A
wi0: Intersil Firmware: Primary 0.03.00, Station 0.08.03
orm0: <Option ROM> at iomem 0xd0000-0xd9fff on isa0
pmtimer0 on isa0
fdc0: ready for input in output
fdc0: cmd 3 failed at out byte 1 of 3
atkbdc0: <Keyboard controller (i8042)> at port 0x60,0x64 on isa0
vga0: <Generic ISA VGA> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
sc0: <System console> at flags 0x100 on isa0
sc0: VGA <16 virtual consoles, flags=0x100>
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 16550A, console
sio1 at port 0x2f8-0x2ff irq 3 on isa0
sio1: type 16550A
ppc0: <Parallel port> at port 0x378-0x37f irq 7 on isa0
ppc0: Generic chipset (EPP/NIBBLE) in COMPATIBLE mode
ppi0: <Parallel I/O> on ppbus0
plip0: <PLIP network interface> on ppbus0
lpt0: <Printer> on ppbus0
lpt0: Interrupt-driven port
IP Filter: v3.4.31 initialized. Default = pass all, Logging = enabled
ad0: 76319MB <ST380011A> [155061/16/63] at ata0-master UDMA100
Mounting root from ufs:/dev/ad0s1a
WARNING: / was not properly dismounted