Hi, We are using asterisk at the office and the incoming line is an ISDN (HFC-PCI card with zap_hfc driver from bristuff 0.2.0 RC3a). And I have a problem, when both ISDN B channels are in use (i.e. 2 calls in progress) it seems that anyone that calls in gets no answer at all, and after 20 seconds or so a voice from the telephone company that says (translated) "It is not possible to connect your call at the moment". In the asterisk console I can se the message "Ignoring callwaiting SETUP on channel 0/0 span 2 0". I think it would be much better if the caller would get a busy tone... Is there any way to accomplish that? Or is this simply a bug? /Ola
Hello, I have the exact same question as you. Did you find an answer?> We are using asterisk at the office and the incoming line is an ISDN > (HFC-PCI card with zap_hfc driver from bristuff 0.2.0 RC3a). > > And I have a problem, when both ISDN B channels are in use (i.e. 2 > calls in progress) it seems that anyone that calls in gets no answer > at all, and after 20 seconds or so a voice from the telephone company > that says (translated) "It is not possible to connect your call at the > moment". In the asterisk console I can se the message > "Ignoring callwaiting SETUP on channel 0/0 span 2 0". > > I think it would be much better if the caller would get a busy > tone... > > Is there any way to accomplish that? Or is this simply a bug? > > /Ola-- Only half the people in the world are above average intelligence.