Hi
No Problem.
I've got a TDM400b board with 2 FXS boards and 2 FXO boards. I'm using
the
fxo board in this fashion as you describe. However, I direct it to
voicemail. What you would do is the following.
In extensions.conf
exten => s,1,Dial(SIP/yourSipConfigName)
This should work fine. You must just make sure that the zaptel channels as
you define them in zapata.conf and the extension definitions are under the
same context.
Regards,
Christiaan
-----Original Message-----
From: asterisk-users-bounces@lists.digium.com
[mailto:asterisk-users-bounces@lists.digium.com] On Behalf Of John Khina
Sent: Thursday, November 18, 2004 1:25 PM
To: asterisk-users@lists.digium.com
Subject: [Asterisk-Users] setup question
Hi All ,
Im planning on setting up Asterisk and was wondering if it was possible
to have it accept calls on a FXO card (TDM400b), then have it deliver
the call to a SIP based IP phone , or do I need to have a FXS module
and analog phones to accept calls via the FXO card?
Thanks ,
JK
_______________________________________________
Asterisk-Users mailing list
Asterisk-Users@lists.digium.com
http://lists.digium.com/mailman/listinfo/asterisk-users
To UNSUBSCRIBE or update options visit:
http://lists.digium.com/mailman/listinfo/asterisk-users