asterisk users - Jul 2004 - Problem with T1 signalling mode

Hi,

I have an Asterisk system (built from CVS 27th May 2004) fitted with a
TE410P card. Spans 1 and 2 are set for T1, B8ZS/ESF. Spans 3 &4 are setup
as PRIs.
On span 1  I have a CAC  Access Bank II (configured to use loop start) and
on span 2 I have a PBX which supports loop start, e&m (wink, immediate,
delayed) and DID. I need to have some channels on the PABX setup as loop
start and some as E&M. However, Asterisk will only run if the signalling on
both T1 spans is the same (all loop start or all e&m). I can not even have
one T1 Span set as loop start and one T1 span as e&m using the following
configuration:


zaptel.conf

span=1,0,0,esf,b8zs
span=2,0,0,esf,b8zs

fxols=1-24
e&m=25-48

zapata.conf

group=2
signalling=fxo_ls
channel=1-24

group=3
signalling=e&m
channel=25-48


I run ztcfg -vv
followed by asterisk -c

Asterisk reports "Signalling requested is e&m wink but line is in FXO
loopstart signalling" followed at the end by " Loading module
chan_zap.so
failed".

Is it possible to get Asterisk to support different signalling modes on T1
spans?
Is there some thing else I need to do?

Regards

Robert Halligan









**********************************************************************
This email and any files transmitted with it are confidential and
intended solely for the use of the individual or entity to whom they
are addressed. If you have received this email in error please notify
postmaster@lakecommunications.com

This footnote also confirms that this email message has been 
scanned for the presence of computer viruses.

www.lakecommunications.com
**********************************************************************