Syslinux - May 2004 - Testing Syslinux on Mazza PT-5VMD

Hi All,
I was testing syslinux floppy on a Mazza MotherBoard, his chipset is VIA 
MVP3 (VT82C598MVP, VT82C586B), and Winbond W83877F/TF.
After reading the floppy, I see 'boot failed', I have to ide disk in the
system, only flash device.
I used the -s option to build the floppy.
Does Somebody know if the chipset is supported? I tested the floppy on 
toshiba laptop and it works very fine.

Thanks in advanced.

Riccardo.

is the physical connection OK?
meaning: no bad floppydrive or (wrongly attached) cable?

BIOS boot sequence?
to mark this as a floppy-booting problem, it would be preferred if you 
boot from another device on the same system, and then try to access and read the
floppy disk. That way you can be sure only booting from the drive fails, not the
reading from it.

Which Syslinux version, and post syslinux.cfg
LDLINUX.SYS is the Syslinux main part, along with some special
bootloader/bootloader mr H Peter Anvin created for his Syslinux project.

Bernd



----------------------------------------------------------------
Op deze e-mail zijn de volgende voorwaarden van toepassing:

http://www.fontys.nl/disclaimer

The above disclaimer applies to this e-mail message.
----------------------------------------------------------------