llvm dev - Jun 2016 - commad "dot" cannot show the complete the control-flow graph in the QED-CFCSS

Dear all,

    I used the command "opt -view-cfg <src.bc> /dev/null" on
ODROID-C2
board (armv8 architecture), however the result of cfg is not complete, it
only shows control-flow-graph of one function.

    Does anyone ever come across this question and just give me some
suggestions? Thanks!

Best,
Liyang
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://lists.llvm.org/pipermail/llvm-dev/attachments/20160620/bf35f682/attachment.html>

On 6/19/16 11:40 PM, 李阳 via llvm-dev wrote:
> Dear all,
>
>     I used the command "opt -view-cfg <src.bc> /dev/null"
on ODROID-C2
> board (armv8 architecture), however the result of cfg is not complete, 
> it only shows control-flow-graph of one function.
Do you want the control flow graph of all functions, or do you want an 
inter-procedural call graph (the two are not the same)?

Regards,

John Criswell
>
>     Does anyone ever come across this question and just give me some 
> suggestions? Thanks!
>
> Best,
> Liyang
>
>
> _______________________________________________
> LLVM Developers mailing list
> llvm-dev at lists.llvm.org
> http://lists.llvm.org/cgi-bin/mailman/listinfo/llvm-dev

-- 
John Criswell
Assistant Professor
Department of Computer Science, University of Rochester
http://www.cs.rochester.edu/u/criswell

-------------- next part --------------
An HTML attachment was scrubbed...
URL:
<http://lists.llvm.org/pipermail/llvm-dev/attachments/20160620/31857389/attachment.html>