Jakub Kicinski
2022-Mar-30 00:54 UTC
[Bridge] [PATCH net-next v2] veth: Support bonding events
Dropping the BPF people from CC and adding Hangbin, bridge and bond/team. Please exercise some judgment when sending patches. On Tue, 29 Mar 2022 13:40:52 +0200 Alexandra Winter wrote:> Bonding drivers generate specific events during failover that trigger > switch updates. When a veth device is attached to a bridge with a > bond interface, we want external switches to learn about the veth > devices as well. > > Example: > > | veth_a2 | veth_b2 | veth_c2 | > ------o-----------o----------o------ > \ | / > o o o > veth_a1 veth_b1 veth_c1 > ------------------------- > | bridge | > ------------------------- > bond0 > / \ > eth0 eth1 > > In case of failover from eth0 to eth1, the netdev_notifier needs to be > propagated, so e.g. veth_a2 can re-announce its MAC address to the > external hardware attached to eth1. > > Without this patch we have seen cases where recovery after bond failover > took an unacceptable amount of time (depending on timeout settings in the > network). > > Due to the symmetric nature of veth special care is required to avoid > endless notification loops. Therefore we only notify from a veth > bridgeport to a peer that is not a bridgeport. > > References: > Same handling as for macvlan: > commit 4c9912556867 ("macvlan: Support bonding events") > and vlan: > commit 4aa5dee4d999 ("net: convert resend IGMP to notifier event") > > Alternatives: > Propagate notifier events to all ports of a bridge. IIUC, this was > rejected in https://www.spinics.net/lists/netdev/msg717292.htmlMy (likely flawed) reading of Nik's argument was that (1) he was concerned about GARP storms; (2) he didn't want the GARP to be broadcast to all ports, just the bond that originated the request. I'm not sure I follow (1), as Hangbin said the event is rare, plus GARP only comes from interfaces that have an IP addr, which IIUC most bridge ports will not have. This patch in no way addresses (2). But then, again, if we put a macvlan on top of a bridge master it will shotgun its GARPS all the same. So it's not like veth would be special in that regard. Nik, what am I missing?> It also seems difficult to avoid re-bouncing the notifier.syzbot will make short work of this patch, I think the potential for infinite loops has to be addressed somehow. IIUC this is the first instance of forwarding those notifiers to a peer rather than within a upper <> lower device hierarchy which is a DAG.> Signed-off-by: Alexandra Winter <wintera at linux.ibm.com> > --- > drivers/net/veth.c | 53 ++++++++++++++++++++++++++++++++++++++++++++++ > 1 file changed, 53 insertions(+) > > diff --git a/drivers/net/veth.c b/drivers/net/veth.c > index d29fb9759cc9..74b074453197 100644 > --- a/drivers/net/veth.c > +++ b/drivers/net/veth.c > @@ -1579,6 +1579,57 @@ static void veth_setup(struct net_device *dev) > dev->mpls_features = NETIF_F_HW_CSUM | NETIF_F_GSO_SOFTWARE; > } > > +static bool netif_is_veth(const struct net_device *dev) > +{ > + return (dev->netdev_ops == &veth_netdev_ops);brackets unnecessary> +} > + > +static void veth_notify_peer(unsigned long event, const struct net_device *dev) > +{ > + struct net_device *peer; > + struct veth_priv *priv; > + > + priv = netdev_priv(dev); > + peer = rtnl_dereference(priv->peer); > + /* avoid re-bounce between 2 bridges */ > + if (!netif_is_bridge_port(peer)) > + call_netdevice_notifiers(event, peer); > +} > + > +/* Called under rtnl_lock */ > +static int veth_device_event(struct notifier_block *unused, > + unsigned long event, void *ptr) > +{ > + struct net_device *dev, *lower; > + struct list_head *iter; > + > + dev = netdev_notifier_info_to_dev(ptr); > + > + switch (event) { > + case NETDEV_NOTIFY_PEERS: > + case NETDEV_BONDING_FAILOVER: > + case NETDEV_RESEND_IGMP: > + /* propagate to peer of a bridge attached veth */ > + if (netif_is_bridge_master(dev)) {Having veth sift thru bridge ports seems strange. In fact it could be beneficial to filter the event based on port state (whether it's forwarding, vlan etc). But looking at details of port state outside the bridge would be even stranger.> + iter = &dev->adj_list.lower; > + lower = netdev_next_lower_dev_rcu(dev, &iter); > + while (lower) { > + if (netif_is_veth(lower)) > + veth_notify_peer(event, lower); > + lower = netdev_next_lower_dev_rcu(dev, &iter);let's add netdev_for_each_lower_dev_rcu() rather than open-coding> + } > + } > + break; > + default: > + break; > + } > + return NOTIFY_DONE; > +} > + > +static struct notifier_block veth_notifier_block __read_mostly = { > + .notifier_call = veth_device_event,extra tab here> +}; > + > /* > * netlink interface > */ > @@ -1824,12 +1875,14 @@ static struct rtnl_link_ops veth_link_ops = { > > static __init int veth_init(void) > { > + register_netdevice_notifier(&veth_notifier_block);this can fail> return rtnl_link_register(&veth_link_ops); > } > > static __exit void veth_exit(void) > { > rtnl_link_unregister(&veth_link_ops); > + unregister_netdevice_notifier(&veth_notifier_block); > } > > module_init(veth_init);
Nikolay Aleksandrov
2022-Mar-30 10:23 UTC
[Bridge] [PATCH net-next v2] veth: Support bonding events
On 30/03/2022 03:54, Jakub Kicinski wrote:> Dropping the BPF people from CC and adding Hangbin, bridge and > bond/team. Please exercise some judgment when sending patches. > > On Tue, 29 Mar 2022 13:40:52 +0200 Alexandra Winter wrote: >> Bonding drivers generate specific events during failover that trigger >> switch updates. When a veth device is attached to a bridge with a >> bond interface, we want external switches to learn about the veth >> devices as well. >> >> Example: >> >> | veth_a2 | veth_b2 | veth_c2 | >> ------o-----------o----------o------ >> \ | / >> o o o >> veth_a1 veth_b1 veth_c1 >> ------------------------- >> | bridge | >> ------------------------- >> bond0 >> / \ >> eth0 eth1 >> >> In case of failover from eth0 to eth1, the netdev_notifier needs to be >> propagated, so e.g. veth_a2 can re-announce its MAC address to the >> external hardware attached to eth1. >> >> Without this patch we have seen cases where recovery after bond failover >> took an unacceptable amount of time (depending on timeout settings in the >> network). >> >> Due to the symmetric nature of veth special care is required to avoid >> endless notification loops. Therefore we only notify from a veth >> bridgeport to a peer that is not a bridgeport. >> >> References: >> Same handling as for macvlan: >> commit 4c9912556867 ("macvlan: Support bonding events") >> and vlan: >> commit 4aa5dee4d999 ("net: convert resend IGMP to notifier event") >> >> Alternatives: >> Propagate notifier events to all ports of a bridge. IIUC, this was >> rejected in https://www.spinics.net/lists/netdev/msg717292.html > > My (likely flawed) reading of Nik's argument was that (1) he was > concerned about GARP storms; (2) he didn't want the GARP to be > broadcast to all ports, just the bond that originated the request. >Yes, that would be ideal. Trying to avoid unnecessary bcasts, that is especially important for large setups with lots of devices.> I'm not sure I follow (1), as Hangbin said the event is rare, plus > GARP only comes from interfaces that have an IP addr, which IIUC > most bridge ports will not have. >Indeed, such setups are not the most common ones.> This patch in no way addresses (2). But then, again, if we put > a macvlan on top of a bridge master it will shotgun its GARPS all > the same. So it's not like veth would be special in that regard. > > Nik, what am I missing? >If we're talking about macvlan -> bridge -> bond then the bond flap's notify peers shouldn't reach the macvlan. Generally broadcast traffic is quite expensive for the bridge, I have patches that improve on the technical side (consider ports only for the same bcast domain), but you also wouldn't want unnecessary bcast packets being sent around. :) There are setups with tens of bond devices and propagating that to all would be very expensive, but most of all unnecessary. It would also hurt setups with a lot of vlan devices on the bridge. There are setups with hundreds of vlans and hundreds of macvlans on top, propagating it up would send it to all of them and that wouldn't scale at all, these mostly have IP addresses too. Perhaps we can enable propagation on a per-port or per-bridge basis, then we can avoid these walks. That is, make it opt-in.>> It also seems difficult to avoid re-bouncing the notifier. > > syzbot will make short work of this patch, I think the potential > for infinite loops has to be addressed somehow. IIUC this is the > first instance of forwarding those notifiers to a peer rather > than within a upper <> lower device hierarchy which is a DAG. > >> Signed-off-by: Alexandra Winter <wintera at linux.ibm.com> >> --- >> drivers/net/veth.c | 53 ++++++++++++++++++++++++++++++++++++++++++++++ >> 1 file changed, 53 insertions(+) >> >> diff --git a/drivers/net/veth.c b/drivers/net/veth.c >> index d29fb9759cc9..74b074453197 100644 >> --- a/drivers/net/veth.c >> +++ b/drivers/net/veth.c >> @@ -1579,6 +1579,57 @@ static void veth_setup(struct net_device *dev) >> dev->mpls_features = NETIF_F_HW_CSUM | NETIF_F_GSO_SOFTWARE; >> } >> >> +static bool netif_is_veth(const struct net_device *dev) >> +{ >> + return (dev->netdev_ops == &veth_netdev_ops); > > brackets unnecessary > >> +} >> + >> +static void veth_notify_peer(unsigned long event, const struct net_device *dev) >> +{ >> + struct net_device *peer; >> + struct veth_priv *priv; >> + >> + priv = netdev_priv(dev); >> + peer = rtnl_dereference(priv->peer); >> + /* avoid re-bounce between 2 bridges */ >> + if (!netif_is_bridge_port(peer)) >> + call_netdevice_notifiers(event, peer); >> +} >> + >> +/* Called under rtnl_lock */ >> +static int veth_device_event(struct notifier_block *unused, >> + unsigned long event, void *ptr) >> +{ >> + struct net_device *dev, *lower; >> + struct list_head *iter; >> + >> + dev = netdev_notifier_info_to_dev(ptr); >> + >> + switch (event) { >> + case NETDEV_NOTIFY_PEERS: >> + case NETDEV_BONDING_FAILOVER: >> + case NETDEV_RESEND_IGMP: >> + /* propagate to peer of a bridge attached veth */ >> + if (netif_is_bridge_master(dev)) { > > Having veth sift thru bridge ports seems strange. > In fact it could be beneficial to filter the event based on > port state (whether it's forwarding, vlan etc). But looking > at details of port state outside the bridge would be even stranger. > >> + iter = &dev->adj_list.lower; >> + lower = netdev_next_lower_dev_rcu(dev, &iter); >> + while (lower) { >> + if (netif_is_veth(lower)) >> + veth_notify_peer(event, lower); >> + lower = netdev_next_lower_dev_rcu(dev, &iter); > > let's add netdev_for_each_lower_dev_rcu() rather than open-coding > >> + } >> + } >> + break; >> + default: >> + break; >> + } >> + return NOTIFY_DONE; >> +} >> + >> +static struct notifier_block veth_notifier_block __read_mostly = { >> + .notifier_call = veth_device_event, > > extra tab here > >> +}; >> + >> /* >> * netlink interface >> */ >> @@ -1824,12 +1875,14 @@ static struct rtnl_link_ops veth_link_ops = { >> >> static __init int veth_init(void) >> { >> + register_netdevice_notifier(&veth_notifier_block); > > this can fail > >> return rtnl_link_register(&veth_link_ops); >> } >> >> static __exit void veth_exit(void) >> { >> rtnl_link_unregister(&veth_link_ops); >> + unregister_netdevice_notifier(&veth_notifier_block); >> } >> >> module_init(veth_init); >