Hi,
I use the bridge these days but I come up with some problems when I use
it.
I add two wifi interfaces to the bridge I call it "br0" . What
I do is as follows :
#brctl addbr br0
#brctl addif br0 eth0
#brctl addif br0 eth1
#ifconfig eth0 0.0.0.0
#ifconfig eth1 0.0.0.0
#ifconfig br0 up
#dhclient br0
The AP gives br0 the address 172.31.24.68 and the gateway is 172.31.24.1
(this detailed address maybe not important though)
I use the command ifconfig and find that the br0's mac is the same as
eth1's . When both the two wifi interfaces are up ,there's no problem
when PING the gateway . But when I ifconfig eth1 down , PING the gateway again
,it shows destination host unreachable . But when I ifconfig eth0 down , it
doesn't affect PING the gateway . I think this may because br0 is bound to
eth1 , the traffic pass through eth1 .
Now here comes the problem . I want br0 bound to eth0 ,what should I do ?
I'm looking forward to your answer and I'm eager to know it. Thank
you very much .
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.linux-foundation.org/pipermail/bridge/attachments/20100414/dcee5732/attachment-0001.htm
Hi,
I use the bridge these days but I come up with some problems when I use
it.
I add two wifi interfaces to the bridge I call it "br0" . What
I do is as follows :
#brctl addbr br0
#brctl addif br0 eth0
#brctl addif br0 eth1
#ifconfig eth0 0.0.0.0
#ifconfig eth1 0.0.0.0
#ifconfig br0 up
#dhclient br0
The AP gives br0 the address 172.31.24.68 and the gateway is 172.31.24.1
(this detailed address maybe not important though)
I use the command ifconfig and find that the br0's mac is the same as
eth1's . When both the two wifi interfaces are up ,there's no problem
when PING the gateway . But when I ifconfig eth1 down , PING the gateway again
,it shows destination host unreachable . But when I ifconfig eth0 down , it
doesn't affect PING the gateway . I think this may because br0 is bound to
eth1 , the traffic pass through eth1 .
Now here comes the problem . I want br0 bound to eth0 ,what should I do ?
I'm looking forward to your answer and I'm eager to know it. Thank
you very much .
-------------- next part --------------
An HTML attachment was scrubbed...
URL:
http://lists.linux-foundation.org/pipermail/bridge/attachments/20100414/af59dbc7/attachment.htm