On 06/04/2018 06:50 PM, Pradeep K.S wrote:> I am planning to configure vlan on vhostuser interfaces in the libvirt
> xml, it throws out error.
> Does this configuration is supported ?
No. configuration of vlan tags within libvirt is only supported for
emulated devices that use a tap device connected to Open vSwitch (i.e.
(<interface type='bridge|network'> .... <virtualport
type='openvswitch'>
..."), or for SRIOV VFs that are assigned to the guest using vfio device
assignment ("<interface type='hostdev'>").
If there is a standard and reasonable method of setting up vlan tagging
for a vhostuser interface from the *host*, then we would consider
accepting patches to implement it (assuming that you want to write them :-).
Otherwise, you'll need to configure the vlan tagging to be done on the
guest (in the guest OS networking config).
> I can install higher version if
> required.
>
> *Error:*
> unsupported configuration: an interface of type 'vhostuser' is
> requesting a vlan tag, but that is not supported for this type of
connection
>
> *Libvirt version:*
> [redhathost@qemu]# libvirtd --version
> libvirtd (libvirt) 3.2.0
>
> *Qemu version:*
> QEMU emulator version 2.9.0(qemu-kvm-ev-2.9.0-16.el7_4.11.1)
>
> *Domain XML*
> *
> *
> <interface type='vhostuser'>
> <mac address='02:3a:c1:4b:a1:0a'/>
> <source type='unix' path='/tmp/vhost-test'
mode='server'/>
> <vlan trunk='yes'>
> <tag id='3' nativeMode='tagged'/>
> <tag id='4'/>
> </vlan>
> <model type='virtio'/>
> <driver rx_queue_size='1024'>
> <host mrg_rxbuf='on'/>
> </driver>
> <address type='pci' domain='0x0000'
bus='0x00' slot='0x03'
> function='0x0'/>
> </interface>
>
>
>
> --
> Thanks and Regards,
> Pradeep.K.S.
>
>
> _______________________________________________
> libvirt-users mailing list
> libvirt-users@redhat.com
> https://www.redhat.com/mailman/listinfo/libvirt-users
>