Hi !! I''m trying to use my bonding in my xen. I ''ve a debian 40r6 etch. The bounding works perfectly without xen. In /etc/modules *bonding miimon=100 mode=balance-alb* when I run xend: *bonding: bond0: first active interface up!* *bonding :bond0 link status definitely up for interface eth1* *bonding: bond0 release slaves* *ADDRCONF(NETDEV_UP): pbond0: link is not ready* *bond0: port1(vif1.0) entering disabled state* My /etc/network/interfaces *auto bond0* *iface bond0 inet static* *address 10.30.102.254* *gateway 10.30.102.5* *netmask 255.255.255.0* *up /sbin/ifenslave bond0 eth0* *up /sbin/ifenslave bond0 eth1* My /etc/xen/xend-config.sxp * (network-script network-bridge) (vif-script vif-bridge) (dom0-min-mem 2024) (dom0-cpus 0) (vnc-listen ''0.0.0.0'') (vncpasswd '''')* According to http://wiki.xensource.com/xenwiki/XenNetworking. "*the bridge (xenbr0), peth0, eth0 and vif0.0 are brought up*". For me when I don''t use the bonding (using eth0)and started xen peth0 and eth0 are bring up but vif0.0 and the xenbr0 are not bring up. After I do "brctl show" and the bridge name is eth0, is correct?? I don''t know if it''s correct but its works!!I can do ping, ssh, connect to vnc of domains... When I start with the bonding (using bond0) only peth0 and pbond0 are bring up. And "brctrl show" put two bridges bond0 and eth0. And the network doesn''t work . any ideas??Are there a tutorial of this or doc? thanks, Alberto _______________________________________________ Xen-users mailing list Xen-users@lists.xensource.com http://lists.xensource.com/xen-users