Xen devel - Dec 2006 - PCI pass through vs. slot

I am a bit confused on the PCI stuff.

PASSTHRU-- does this mean that pcifront is not needed? Or only that
the PCI is not limited as it is with slot.

In general, none of the docs are getting me anywhere with xen 3.0.3.
Example: I run this:
  echo -n 0000:2:0.1>/sys/bus/pci/drivers/pciback/new_slot
  echo -n 0000:2:0.0>/sys/bus/pci/drivers/pciback/new_slot
  echo -n bind 0000:2:0.0 > /sys/bus/pci/drivers/pciback/bind
  echo -n bind 0000:2:0.1 > /sys/bus/pci/drivers/pciback/bind


It fails in one of two ways. If there is a driver present for that
device, the driver symlink has a value, and it seems that it can not
be changed to "pciback".

if there is no driver present, there is no driver symlink, and xen
seems not be be able to set it. So the domain can not be started.

Any good writeups on PCI passthrough? I need Plan 9 to have raw access
toa device.

ron

_______________________________________________
Xen-devel mailing list
Xen-devel@lists.xensource.com
http://lists.xensource.com/xen-devel

On 5/12/06 6:41 pm, "ron minnich" <rminnich@gmail.com> wrote:
> I am a bit confused on the PCI stuff.
> 
> PASSTHRU-- does this mean that pcifront is not needed? Or only that
> the PCI is not limited as it is with slot.
No, it means that the device address (bus,slot,fn) is ''passed
through''
unmodified to pcifront, with no remapping. You still need pcifront!

 -- Keir


_______________________________________________
Xen-devel mailing list
Xen-devel@lists.xensource.com
http://lists.xensource.com/xen-devel