Displaying 20 results from an estimated 900 matches similar to: "aMule"
2005 Feb 01
4
Shorewall problem
I am getting the following message when Shorewall stops can anybody shed
any light on this message and where I should be looking? Thanks
root@bobshost:~# shorewall stop
Loading /usr/share/shorewall/functions...
Processing /etc/shorewall/params ...
Processing /etc/shorewall/shorewall.conf...
Loading Modules...
Stopping Shorewall...Processing /etc/shorewall/stop ...
IP Forwarding Enabled
2005 Jun 24
6
Is it that difficult?
Hello,
You will find in attachment the layout of my
current physical configuration.
For now, the Cable ISP is not used. Since it
is a dynamic ISP, my mailserver is rejected and
my domain name registers on blacklists like ORDB
and al.
I want it to be used as a default gateway except
for my mail server that would be seen as coming
from my "honest" ADSL ISP.
Here is
2004 Aug 30
6
Shorewall upgrade messed up my firewall
Hi all,
I''m using Gentoo Linux Distribution and I''ve upgraded my firewall
from Shorewall 1.4 to 2.0.4, however my LANs stop having internet
access.
I have a server with shorewall 2.0.4 installed and 3 interfaces.
eth0 and eth1 are interfaces to a LAN and to my laptop and eth2
is the net interface.
I have masq like:
eth2 eth0
eth2 eth1
2004 Sep 24
10
hopeless - smb over bridged firewall
Dear List!
I use a shorewall 2.0.8 on a Debian sarge system. I use a DSL connection
to the Internet (ppp0 - eth1 to the modem) and a bridge to the local
lan. The bridged config i''ve made with bridge.html from the shorewall
site. The Bridge is between local net and a openvpn tap device. This
works. I ccan make tunnels, and a can make a lot of things through the
firewall. I can get a list
2004 Dec 28
5
Multiple IP´s in one Zone
Hi everybody
I have a Problem with Masquerading from my local net (loc) to my VPN (loc2).
I can reach every Service from loc2 in loc, but I can''t get reach any
service from loc in loc2.
Has somebody an Idea where my mistake is ?
Without shorewall, it was working.
Thanks for helping
Lars
Technical Information :
Shorewall 2.0.13
Suse 9.0
*177.177.77.X The first 3 Counts are changed
2004 Aug 05
9
Not able to access website
Hi,
Trying to figure out why I cannot get access to dell.com
Their site is up because I can browse using a different firewall.
Trying to find out where the logs are located and what log files it
would write to if it were to deny browsing to a website. I can see the
[UNREPLIED] when using the shorewall status. Was hoping to know what
logfile it is writing it to.
Thanks in advance,
Elmer
2005 Mar 07
10
DNS Name problem with mail server on LAN
Hi,
I have a big "name problem" with my internal mail server (10.0.0.152).
It is "seen" on the internet through DNAT (213.58.230.27). Also there is a
MX record pointing to the machine. Everything works fine from the outside.
However i can''t set the mail clients on the lan pointing to the mx record,
because this one points to 213.58.230.27 and the firewall
2004 Dec 04
7
vpn-zone wide open
Hello!
I am using shorewall shorewall-2.0.11-1 on fedora core2
(iptables-1.2.9-95.7). My box has 2 physical nic´s plus one virt. ipsec
interface for a freeswan-vpn connection.
A few days ago, portsentry spit out a lot of connections from windows
clients (port 135, 445). Ooops.
I review my shorewall settings but could not find a mistake. So I took a
win-client and established a second
2005 Jan 09
19
Shorewall and CUPS printing interference
I''m having a problem with the Shorewall firewall and CUPS printing
interfering with each other. My Linux firewall machine is acting as both
a CUPS server and client for all of my tests.
Shorewall 2.0.13
CUPS 1.1.22-2
Linux kernel 2.6.9
CUPS was working fine to print to my Epson C84 (network connected via a
Netgear PS101 print server using lpd://PS101.IP.address/raw ) until I
2005 Feb 02
1
Masq errors?
Hi all,
I have a problem with a new Shorewall box I''m trying to migrate from
iptables rules to shorewall 2.2.0.
I have a 3 interfaces setup:
- eth0 ---> internet (ip address)
- eth1 ---> remote office (10.0.0.0/8)
- eth2 ---> lan (192.168.16.0/24)
I''m using a very simple and common setup, with just a few DNAT rules in
my /etc/shorewall/rules file, and about twenty
2005 May 29
17
Plans for 2.4.0
Hi folks,
Has anyone tested the changes to multiple ISPs/load balancing or
routestopped in 2.4.0-RC1 yet? We need to talk about what criteria we
will use for determining whether 2.4.0 is ready for release.
I''ve started configuring a firewall at work with the multiple ISPs
support, but its kernel doesn''t have connection marking support, so it''s
going to be a couple of
2004 Dec 28
14
DHCP
Good day to all.
I don''t like to Post unless I am really stuck. Guess what?
Redhat with Shorewall. Been using this for years. I have a new client that we have setup with Redhat and Shorewall. The problem is that his outside address (ETH0 = NET) is dynamic (i.e. DHCP enabled).
All the rules work fine when we use a STATIC address on Eth0, so we know the rules, filters, tos etc work fine
2004 Dec 29
18
No response on port 80 with Shorewall
I have problem getting answer on http request from all my local subnets
but not from local subnet.
Ping and requests on ports 21 22 23 25 110 works fine.
I logged port 80 in rules files and I got
accept entry same for local subnet and other subnets.
Local subnet is 192.168.6
Dec 29 09:52:40 zinfsrv2 kernel: Shorewall:loc2fw:ACCEPT:IN=eth0 OUT=
MAC=00:09:6b:07:ca:cc:00:10:b5:fa:bd:71:08:00
2005 May 31
11
More Tests for 2.4.0-RC2 - strange behaviour
Hi all,
I was trying to test ROUTE specific code with a multi-isp serviced box.
There is a bug somewhere, but I''m not able to understand what the real
problem is:
when I issue a "shorewall show capabilities" I get:
Loading /usr/share/shorewall/functions...
Processing /etc/shorewall/params ...
Processing /etc/shorewall/shorewall.conf...
Loading Modules...
Shorewall has
2004 Sep 13
5
Config problems
Hi,
I have a working test install of Shorewall 2.0.7 on a
32 bit install of Gentoo, it''s working like a champ,
so i am making an install on a nice new Opteron
server, using 64bit Gentoo.
I have run into a problem which going by your FAQ
might be due to a missing module, but after a couple
of hours of fiddling I''m stumpted - I can''t see any
options in the 2.6.8 kernel
2004 Aug 12
1
SMTP, IP, WHM news problems....
Hi,
I install shorewall firewall on my server and after that I have big
problem with SMTP, I can send messages with outlook to server but that
messages don`t go out from server (Currently I have over 800 messages
in the mail queue)
My server is on WHM/cPanel and EXIM....
When I click on "Delivery Now" for some message in WHM I get error:
Message 1BtoLi-00033G-RN is not frozen
LOG: MAIN
2005 Jul 02
6
Port redirection on standalone pc to pop3 proxy AV scanner
G''day all.
I''m trying to set up Clam AV scanning of incoming POP3 email to my
Thunderbird mail client; I have a standalone laptop with a 56k dialup
connection to my ISP.
I can''t seem to get port redirection working: I''m trying to redirect
incoming POP3 mail from my ISP''s mail server to p3scan which is
listening on 127.0.0.1:8110 and will do the AV
2004 Jan 12
0
Shorewall2 -- now running on gateway.shorewall.net
I''ve gotten the basic code working on my firewall.
So that I can quickly get back online if I screw up, I''m currently calling it
shorewall2. That way if it screws up I can just "shorewall restart".
/sbin/shorewall2 -- command interpreter
/etc/shorewall2/ -- configuration files
/usr/share/shorewall2/ -- shared files
Both Shorewall and Shorewall2 use the
2005 Feb 28
1
Mail server on DMZ
Hello,
I have this problem: when my mail server on the DMZ starts a connection to
the internet it''s ip (213.58.230.26) is "masqueraded" with the firewall ip
(213.58.230.50). I wouldn''t mind but there is a one customer who rejects the
connection because it makes reverse dns and finds no dns entry for the
firewall ip.
How can i correct this?
Thanks,
MSantos
shorewall
2004 Nov 29
2
SFTP
(anonymous post) I have a simple 2 interface firewall setup and all is
good, almost. I am hosting virtual websites and DNS behind shorewall no
problem. However I am trying to use SFTP via a different port number and
have no luck even though Putty works well. Is there anything weird to
sftp and shorewall? My lab uses a different firewall (firestarter) and
it works OK.
I am using;
DNAT net