similar to: Openswan <-> VyOS

Hello, I'm cross posting this from the OpenSwan mailing list, in case someone here can help. We have two sites connected via OpenSwan 2.6.32-9 on CentOS 5, sharing 6 /24 subnets each (so 12 in total). The problem we're having is completely randomly, be it in the middle of the day, or in the middle of the night (so I don't believe it's traffic related), certain (and sometimes

Does anyone else noticed problems after updating openswan to openswan-2.6.32-27.2.el6_5.i686 ? In our case a connection to Cisco VPN 3000 Series would no longer work. I can see in the log an ASSERTION FAILED error and the connection would remain in Pending phase 2. Mar 7 16:24:40 firewall pluto[7647]: "ciscovpntest" #2: discarding duplicate packet; already STATE_MAIN_I1 Mar 7

Try setting lower keyexpiry time on other endpoint. -- Eero 2016-02-09 17:04 GMT+02:00 John Cenile <jcenile1983 at gmail.com>: > Hello, > > I'm cross posting this from the OpenSwan mailing list, in case someone here > can help. > > We have two sites connected via OpenSwan 2.6.32-9 on CentOS 5, sharing 6 > /24 subnets each (so 12 in total). > > The problem

Well. Centos 5 is really near of it's end of life. There is not much updates to kernel or openswan. You should at least try latest openswan version. Your issue looks like a bit network problem. -- Eero 2016-02-10 8:34 GMT+02:00 John Cenile <jcenile1983 at gmail.com>: > So lowering the keylife / ikelifetime didn't solve the problem. I've > enabled debugging and I'll

As I said though, there's no lost ICMP packets, even when the IPSec tunnel drops out. I do notice a lot of these errors in the secure log though, would this be any indication of a problem? (I'm grepping for this specific error, they're not the only messages in there). Feb 11 14:18:10 site-a pluto[10450]: "site-b/1x1" #803: ignoring Delete SA payload: PROTO_IPSEC_ESP

IF you are not stuck to IPSec, you might want to take a look at OpenVPN (www.openvpn.org). I found OpenVPN easier to install than FreeSWAN (an IPSEC VPN) and have setup an OpenVPN solution between my German office and our mainoffice in a matter of hours. Thom van der Boon E-Mail: Thom.van.der.Boon at vdb.nl ===== Thom.H. van der Boon b.v. Havens 563 Jan Evertsenweg 2-4 NL-3115 JA Schiedam

Hey All, I don't know what's wrong, or what I may have done wrong, but I THOUGHT I followed all the correct steps to setup samba, and it's not working. Here's what I did: D/L latest samba code (4.13.1) & extract install dependencies ./configure --prefix=/usr/local --enable-fhs (enable-fhs was required to get configure to run through completely) make make install cp

hi, I can''t get a freeswan 2.02 ipsec x509 connection at work can somebody help me? ************************************************************************************* global situation ************************************************************************************* the linux gateway (chivas) is a single machine 192.168.1.250 with a local net 192.168.1.0/24, a dyn IP via a DSL

Full_Name: Enrico Pegoraro Version: 2.7.2 OS: Windows (Vista or Xp PRO) Italian Submission from: (NULL) (87.4.189.202) If you send these lines of code: outdir="c:/pippo" file.path(outdir,"pluto.html") R replies correctly: [1] "c:/pippo/pluto.html" But if you change the first steps to: outdir="" file.path(outdir,"pluto.html") R replies

Hi, is there anybody running centos3 (el3) with a standard kernel 2.4.32 or newer, because it seems openswan versions > 2.21 don''t run with centos3(el3) anymore. But we need the newer openswan versions. Problem arise when I try to build the ipsec.o module: /usr/src/openswan-2.4.4/linux/net/ipsec/ipsec_init.c /usr/src/openswan-2.4.4/linux/net/ipsec/ipsec_init.c: In function

Does anyone know if I can use traceroute on a vpn connection to see if everything on my end is working ok? I ran ipsec eroute and it shows the tunnel is up and passing traffic to it but just curious what all tests that I can run on them. -- Andrew Rice Jr Systems Analyst Carrier Management Systems, Inc. 500 Chestnut Street, Suite 500 Abilene, TX 79602 USA support: (325) 672-0975 office:

Hi Denis, on both samba hosts (donald and pluto) these commands work great: id johndoe getent group getent passwd My pluto:/etc/nsswitch.conf looks like that: [...] passwd: compat ldap group: compat ldap shadow: compat ldap [...] I want to add, that the described problem works fine if I try it on a share on "donald", my domain controller. The users are

On 10/05/2010 09:42 AM, hamed hamzehi wrote: > Hi > yes, I'm asking for any advice, I want to implement multithreaded code > generator in LLVM. > tnx Hi, this generally depends which kind of code you want to multithread, because generally this is a difficult problem. However, if you limit yourself for the moment to loops that fit into the polyhedral model, you can take

Centos 5 is still soon end of life. Using it as ipsec gateway is .. Eero 21.3.2016 7.25 ip. "Mike - st257" <silvertip257 at gmail.com> kirjoitti: > On Mon, Mar 21, 2016 at 1:17 PM, Mike - st257 <silvertip257 at gmail.com> > wrote: > > > I second Eero's comment, use a new IPSec daemon. > > > > Openswan was forked and became Libreswan. Paul, now

Err. Sounds like security nightmare. 21.3.2016 7.47 ip. "Glenn Pierce" <glennpierce at gmail.com> kirjoitti: > Will ask my boss :) We are hosted on memset so not so easy to update > > Thanks > > On 21 March 2016 at 17:36, Eero Volotinen <eero.volotinen at iki.fi> wrote: > > Centos 5 is still soon end of life. Using it as ipsec gateway is .. > >

I second Eero's comment, use a new IPSec daemon. Openswan was forked and became Libreswan. Paul, now a RH employee, was a main developer for the Openswan project before he and others created the Libreswan fork. https://libreswan.org/ EL6 has Openswan EL7 has Libreswan Racoon isn't all that fun to work with. If you have the option, ditch it and EL5 and move to a newer platform

I looked in the yum repositories for CentOS 7 and I noticed that there are no packages for any of the major open source IPSec VPN apps - Openswan, strongSwan, etc. I'm pretty sure CentOS 6 had Openswan packages. What is the current consensus w.r.t. building an IPSec VPN "server" (concentrator, whatever) on CentOS 7, that will do site-to-site connections with Cisco hardware at

Hi List, i found a Problem with the CentOS RPM for OpenSwan exactly its the Version: openswan.i386 2.6.14-1.el5_3.2 . If you set the Pluto Debug-Level in the ipsec.conf to "all" (Exactly the line looks like this" plutodebug="all" ") and now a client connect to the Server the Ipsec gets an Segmentation Fault and is killed. We Authenticate our clients with x509

On 2015-04-14 11:25, Gordon Messmer wrote: > On 04/14/2015 11:07 AM, Florin Andrei wrote: >> I looked in the yum repositories for CentOS 7 and I noticed that there >> are no packages for any of the major open source IPSec VPN apps - >> Openswan, strongSwan, etc. I'm pretty sure CentOS 6 had Openswan >> packages. > > libreswan replaced openswan, and is

Dear all, I am struggling around with Windows ACLs and cannot find a solution nor how to troubleshoot that. I have two samba3 hosts. Hostname "donald" is my domain controller with samba 3.x + OpenLDAP server running. Hostname "pluto" is my other samba 3.x server which was joined to my domain. I use LDAP for my users+groups. I dont have winbind on my machines. On hostname