similar to: Preparations for Fermi DRAM clock changes

Displaying 20 results from an estimated 1000 matches similar to: "Preparations for Fermi DRAM clock changes"

2017 Apr 10
14
RESEND Preparations for Fermi DRAM clock changes
Two patches went missing as a result of PEBCAK. No v2 marks as nothing changed really. Just resending for easier enforcement of patch order in other people's trees. Sorry for the noise. Original message: No, no, these will not implement Fermi reclocking. This set of patches contains some of the preparatory work that I deem stable enough to move upstream. Notable changes - Training pattern
2015 Sep 29
10
All-round reclocking improvements
In bulletpoints: - Add some support for G94 and G96 reclocking. Has been tested on literally two cards, which is hardly adequate as "full coverage". On the other hand, the changes were small enough to make me confident this might work for others as well. - Fix NV50 wait for VBLANK when no monitor is plugged in. - Voltage related inprovements for GT21x. - Slightly improve Keplers
2015 Jul 05
1
[RFC] Fermi/Kepler identify DLLoff
Hello, Attached a small patch that correctly identifies the DLLoff bit for >=GF100. Marked RFC because I haven't seen any GDDR5 samples that *enable* the DLL. I'd like to verify whether the DLL should be reset when enabled. Could increase likelihood of succesfull reclock. Ben: could you do some experiments with this bit to see if GDDR5 needs some DLL reset logic? Thanks, and happy
2014 Sep 12
6
NVA3: Small misc mem reclocking fixes
Patch 1 fixes nva3 bailing due to not finding the right ramcfg Patch 2 is a resend rebased on 3.17.0-rc4 for setting the vblank period Patch 3-5 handle writes to per-partition registers, for which NVA3 does not have special broadcast regs available. Patch 6 removes local structs from NVA3 reclocking in favour of the already existing "ram->base." variables, like in NVE0 As always,
2014 Sep 29
18
Implement reclocking for DDR2, DDR3, GDDR3
Following a series of patches that implement memory reclocking for NVA3/5/8 with DDR2, DDR3 and GDDR3 on board. I tested these patches on 6 different graphics cards, but I expect reclocking now to work on many more. Testers can pick up these patches and test it by enabling pstate (nouveau.pstate=1). They should then be able to change clocks by writing to /sys/class/drm/card0/device/pstate. Correct
2017 Apr 10
0
[PATCH 03/11] nvkm/gddr5: MR calculation for timing table v1.0
Merges in skeggsb's: "fb/ram/gf10x: timing_10_0e_30" Todo: - find l3, rq - triple-check Signed-off-by: Roy Spliet <nouveau at spliet.org> --- .../drm/nouveau/include/nvkm/subdev/bios/ramcfg.h | 12 +++--- drivers/gpu/drm/nouveau/nvkm/subdev/bios/rammap.c | 22 ++++++++-- drivers/gpu/drm/nouveau/nvkm/subdev/bios/timing.c | 2 +
2016 Sep 21
8
[PATCH 0/5] GPU-DRM-nouveau: Fine-tuning for five function implementations
From: Markus Elfring <elfring at users.sourceforge.net> Date: Wed, 21 Sep 2016 09:09:09 +0200 A few update suggestions were taken into account from static source code analysis. Markus Elfring (5): Use kmalloc_array() in nvbios_iccsense_parse() Use kmalloc_array() in gt215_link_train() Delete unnecessary braces Adjust a kzalloc() call in gt215_ram_new() Add space after an
2017 Jul 28
2
[PATCH] ramgf100: Fix small typo.
Signed-off by: Rosen Penev <rosenp at gmail.com> --- drm/nouveau/nvkm/subdev/fb/ramgf100.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drm/nouveau/nvkm/subdev/fb/ramgf100.c b/drm/nouveau/nvkm/subdev/fb/ramgf100.c index 4a9bd4f1..feb8820c 100644 --- a/drm/nouveau/nvkm/subdev/fb/ramgf100.c +++ b/drm/nouveau/nvkm/subdev/fb/ramgf100.c @@ -717,7 +717,7 @@
2017 Dec 29
1
[PATCH] ramgf100: Fix small typo.
This is fixed in a different nouveau branch. from Ben Skeggs last I remember. On Fri, Dec 29, 2017 at 1:37 PM, Pierre Moreau <pierre.morrow at free.fr> wrote: > The typo is still present in master. > Not sure whether it will help you Ben, regarding Fermi reclocking, but it > shouldn’t harm in reducing possible errors. :-) > > Regards, > Pierre > > On 2017-07-27 —
2016 Aug 16
21
[PATCH v5 00/20] Engine Reclocking Fixes for Fermi-Maxwell2
I've splitted my big series between the part which actually fixes the engine reclocking bits and the part handling voltage/clock updates on temperature change, so that the more reviewed parts can be merged in faster. This series fixes a lot of Engine reclocking issues found on Fermi, Kepler and all Maxwell generation GPUs. It does _not_ fix memory reclocking on Fermi. It mostly contains of
2015 May 22
11
Reclocking support for NVA0
Adds reclocking for NVA0, and a whole lot of work for other cards. Had these patches collecting dust for a little, but tested them with both my NVA0, and Martin's a while back. Success not guaranteed, but should be quite a leap forward. Happy reviewing and testing. Cheers, Roy
2017 Apr 10
0
[PATCH 02/11] nvkm/ramgf100: Calculate timings
Todo: - Determine source of R[10f298] & 0x11 Signed-off-by: Roy Spliet <nouveau at spliet.org> --- drivers/gpu/drm/nouveau/nvkm/subdev/fb/ramgf100.c | 115 ++++++++++++++-------- 1 file changed, 76 insertions(+), 39 deletions(-) diff --git a/drivers/gpu/drm/nouveau/nvkm/subdev/fb/ramgf100.c b/drivers/gpu/drm/nouveau/nvkm/subdev/fb/ramgf100.c index fffd01a..6ebdc4c 100644 ---
2017 Apr 10
0
[PATCH 04/11] nvkm/ramgt215: Move ram training up the chain
Parts are re-used even on NVA3, others from GF100 on Signed-off-by: Roy Spliet <nouveau at spliet.org> --- drivers/gpu/drm/nouveau/nvkm/subdev/fb/ram.h | 17 +++ drivers/gpu/drm/nouveau/nvkm/subdev/fb/ramgf100.c | 92 +++++++++----- drivers/gpu/drm/nouveau/nvkm/subdev/fb/ramgk104.c | 140 +--------------------- drivers/gpu/drm/nouveau/nvkm/subdev/fb/ramgt215.c | 61 ++++++++++ 4
2017 Apr 10
0
[PATCH 08/11] nvkm/ramgt215: Add train ptrn upload for GDDR5
Signed-off-by: Roy Spliet <nouveau at spliet.org> Tested-by: Ilia Mirkin <imirkin at alum.mit.edu> --- drivers/gpu/drm/nouveau/nvkm/subdev/fb/ram.h | 1 + drivers/gpu/drm/nouveau/nvkm/subdev/fb/ramgt215.c | 128 +++++++++++++++++----- 2 files changed, 99 insertions(+), 30 deletions(-) diff --git a/drivers/gpu/drm/nouveau/nvkm/subdev/fb/ram.h
2017 Apr 10
0
[PATCH 01/11] nvkm/ramgf100: Get rid of (size, data) pairs for rammap, ramcfg, timing
In correspondence with the other ram_calc implementations. Signed-off-by: Roy Spliet <nouveau at spliet.org> --- drivers/gpu/drm/nouveau/nvkm/subdev/fb/ramgf100.c | 37 ++++++++++++----------- 1 file changed, 19 insertions(+), 18 deletions(-) diff --git a/drivers/gpu/drm/nouveau/nvkm/subdev/fb/ramgf100.c b/drivers/gpu/drm/nouveau/nvkm/subdev/fb/ramgf100.c index 093223d..fffd01a 100644 ---
2015 May 24
3
[PATCH v2 07/10] bios/ramcfg: Separate out RON pull value
Signed-off-by: Roy Spliet <rspliet at eclipso.eu> --- drivers/gpu/drm/nouveau/include/nvkm/subdev/bios/ramcfg.h | 1 + drivers/gpu/drm/nouveau/nvkm/subdev/bios/rammap.c | 3 ++- drivers/gpu/drm/nouveau/nvkm/subdev/bios/timing.c | 2 ++ drivers/gpu/drm/nouveau/nvkm/subdev/fb/gddr3.c | 6 ++++-- 4 files changed, 9 insertions(+), 3 deletions(-) diff --git
2014 Sep 04
10
MEMX improvements + DDR 2/3 MR generation
Patch 1 and 2 implement wait-for-vblank, required to remove flicker when reclocking memory Patch 3 and 4 allow me to do things between waiting for VBLANK and disabling FB, like pause PFIFO and wait for the engines to idle. This minimises the time PFIFO is paused, thus maximises performance. The rest of the patches speak for themselves. As the actual memory reclocking script is still somewhat prone
2018 Oct 17
2
[PATCH] drm/nouveau/nvkm: mark expected switch fall-throughs
In preparation to enabling -Wimplicit-fallthrough, mark switch cases where we are expecting to fall through. This patch aims to suppress 29 missing-break-in-switch false positives. Addresses-Coverity-ID: 1456891 ("Missing break in switch") Addresses-Coverity-ID: 1324063 ("Missing break in switch") Addresses-Coverity-ID: 1324063 ("Missing break in switch")
2020 Jul 07
3
[PATCH][next] drm/nouveau: Use fallthrough pseudo-keyword
Replace the existing /* fall through */ comments and its variants with the new pseudo-keyword macro fallthrough[1]. Also, remove unnecessary fall-through markings when it is the case. [1] https://www.kernel.org/doc/html/latest/process/deprecated.html?highlight=fallthrough#implicit-switch-case-fall-through Signed-off-by: Gustavo A. R. Silva <gustavoars at kernel.org> ---
2016 Mar 04
2
[PATCH 0/2] enable memory reclocking on maxwell1
A quick look over the memory reclocking part inside the maxwell mmiotraces kind of reminded me of the kepler memory reclocking, it looks for most parts the same. I didn't do a deep inspection so treat this with great care, but it seems to work at least on those maxwell gpus this was tested on. It depends on the PMU fixes for the fuc5 though, otherwise the PMU might not work as expected and