similar to: Unisteam not showing callerid

Hi [Feb 17 07:59:45] WARNING[21539]: channel.c:3477 ast_request: No channel type registered for 'USTM' [Feb 17 07:59:45] WARNING[21539]: app_dial.c:1502 dial_exec_full: Unable to create channel of type 'USTM' (cause 66 - Channel not implemented) == Everyone is busy/congested at this time (1:0/0/1) I get this after I restart my asterisk 1.6, it all worked yesterday. I have the

Hello, I have an Asterisk 1.8.11 installation. When I built up this Asterisk, I didn't install DAHDI channel, if I issue command connect*CLI> core show channeltypes I would have response like: connect*CLI> core show channeltypes Type Description Devicestate Indications Transfer ---------- -----------

Hello list! I?m having an issue when reloading Asterisk, I?ve had this problem in Asterisk 1.6.1.6 so I upgrade to 1.6.2.1 version, but I still have the same error. For example, I send a "reload" in Asterisk CLI and this is the output: isb152*CLI> reload == Parsing '/etc/asterisk/extconfig.conf': == Found == Parsing '/etc/asterisk/manager.conf': == Found

Hello everyone! I installed Asterisk following the instructions of the book "Asterisk: The Future of Telephony". (very nice book) However, I failed. I installed zaptel, libpri and asterisk (in this order). The Installation of Zaptel is successful and my TDM400P is correctly detected: # zttool Alarms Span OK Wildcard S400P

Hi When i try to transfer calls from my ip2002 phone in asterisk 1.6, I can make the transfer and it rings on the extension I transfer to, but when I accept the call, asterisk dumps. How can I get it to work? And how do I save the dump error? Regards /ralf ________________________________________________ Ralf Tr?skman, IT AdLibris AB, Odengatan 106, 113 22 Stockholm, Sweden Dir: