similar to: emule and udp

I had been using L7-Filter[1] successfully for edonkey/eMule traffic until recently. I upgraded to the latest release of mldonkey, 2.5.28a, which implements eMule compatibility, and with support for Kademlia[2] enabled, network latency increases greatly. [1] http://l7-filter.sourceforge.net/ [2] http://www.infoanarchy.org/wiki/wiki.pl?Kademlia Has anyone created a new pattern match for

Hi all! I have to ask you people for some help about eMule 0.50a running with wine 1.2 on Ubuntu 10.04LTS Lucid Lynx 64bit. I installed wine 1.2 beta from the official lucid repos (which btw has become final), and eMule 0.50a. I used to do so in the past, but now i can't realize why i can't get a HighID, which is needed to get optimal performance while sharing. I configured eMule as usual

Hi to everybody, I write because I have just configure a shorewall to be used as firewall, proxy(with squid) and gateway to 2 internet connections, and it looks to work properly but now I''d like to add a new feature: I would to redirect some specific traffic (emule''s one) only to one of those links. This is my diagram:

emule 0.48a on a from-source-compiled-without-compiler-optimizations Wine 1.1.7 uses excessive (infinite) amounts of memory with an estimated consumption rate of 1MB/minute until the system runs out of memory, I have yet to test other versions of either wine or emule, but I suspect this: wine or emule versions do not matter, there will always be a memory leak, and it is obvious that it is not a

Hi, I need to block eMule program. How can I make it ? Best Regards, Anderson.

Emule version: 0.49b OS: Debian Lenny Pc: Pentium III 800 Mhz 512 MB RAM, 2 GB swap Wine version: 1.1.13 When i launch it, the memory usage is around 80 MB, few hours later it is about 300 MB and after 2 day 1.8 GB when my upload is at 20 KB/s. Emule then ends up eating all the memory (2GB swap included). eMule runs with a WebServer activated and with no native dll, only Wine's dll. I've

Hello, I'm brand spanking new with Linux and all of this. I've just recently installed Ubuntu, and I installed Wine. I've just now attempted to install the latest version of emule into Wine, and it was easier than I expected. One thing though-emule didn't get added to the applications/wine/programs menu. How does one add programs to that menu? I had to browse the "c"

I?m using Ubuntu 10.04 & wine 1.2rc2,and my emule crashes every time. I prefer using VeryCD emule because I?m living in China. There?s poor network condition here. i found that if i run Xtreme8.0 beta and VC emule at the same time,it will be more stable. here?s my command line output: Code: fixme:ole:CoInitializeSecurity ((nil),-1,(nil),(nil),4,3,(nil),0,(nil)) - stub!

Can somebody tell me why this eMule-Mod crashes, its Ubuntu 10.04 & Wine 1.2 ??? Here is the terminal output: > > ???@???:~/.wine/drive_c/Mods/eMule 0.50a No.Name$ wine emule.exe > fixme:advapi:RegisterTraceGuidsW (0x100778a, 0x100a060, {485e7de8-0a80-11d8-ad15-505054503030}, 1, 0x33fe00, (null), (null), 0x100a068,) > fixme:advapi:RegisterTraceGuidsW (0x100778a, 0x100a080,

Hi, I''ve installed Emule (p2p program) on my client box but I can''t access the servers due to the firewall. I''m getting this blocking errors: Jan 22 01:26:07 servidor kernel: Shorewall:net2all:DROP:IN=eth1 OUT=eth0 SRC=213.22.49.86 DST=192.168.0.3 LEN=60 TOS=0x00 PREC=0x00 TTL=57 ID=50538 DF PROTO=TCP SPT=46408 DPT=4662 WINDOW=5840 RES=0x00 SYN URGP=0 My rules file

Hi All , My first message and I have a little problem with my FC6 box trying to block emule traffic using layer7 . Here my network : Internet --------- ADSL Router ------------------- FC6 Box -------------------- Emule Box external ADSL : Dynamic Internal ADSL : 192.168.254.1 external FC6 : 192.168.254.3 internal FC6 : 192.168.253.1 Emule Box : 192.168.253.3 I guess that everything

I notice most things say to open ports 10000-20000 for UDP for SIP, however from time to time this range isn't where Asterisk is opening the ports: We're at xxx.xxx.xxx.xxx port 8542 Answering with capability 0x2(GSM) Answering with capability 0x4(ULAW) Answering with capability 0x8(ALAW) This call has no audio, presumably because port 8542 is firewalled in the iptables on the server.

I have been running WinMX for a while on Wine, and while it has a few quirks, it works (for the most part) quite well. eMule, OTOH, flat refuses to start and throws an unhandled exception: page fault... Has anyone here had any luck running other P2P programs via wine?

Hi eMule is working very slow in showing screen statistics and other things. What can be done to make it faster ? OW

Anyone have any luck running any of the following under current versions of wine? They worked with older version, but none of these work now. emule .47c winmx 3.5.4 bpftp 2.4.0 (bullet proof ftp server) totalcommander 6.54a

Hi all, i need advice how can i limit ip_conntrack per IP. clients of network that i support often uses torrent , DC++ , eMule clients and i have lost packages because they open too many ports. i have traffic control limits but this obviously isn''t enough Any advance how to prevent server from this kind problems will be welcome. Best regards Emil

https://bugzilla.netfilter.org/show_bug.cgi?id=839 Summary: SNAT66 does not work for bidirectional UDP Product: netfilter/iptables Version: unspecified Platform: x86_64 OS/Version: Gentoo Status: NEW Severity: normal Priority: P5 Component: NAT AssignedTo: netfilter-buglog at lists.netfilter.org

Hello, I guess a few of you know about the iptables-p2p project at the http://sourceforge.net/projects/iptables-p2p site. This suite has an excellent filter of which I use today and its running very smoothly. The main reason why I use this is because I desperately need to block torrents. IPP2P does not do this at this time (it seems to me in the doc at least). Is it maybe some way we could merge

Hello, A little informal input on the TCP/UDP checksum deferral/offload: it fails for me. I have one Xen host, running a snapshot of xen-unstable at 2006-03-24 (9435:11fee62328cc). Each of its domUs are allocated their own /30, with the help of a hacked-up vif script. Prior to working around the problem, Domain-0 could establish TCP connections to other domains. In the case of SSH, it would

Hi list, I have a VPN mesh with ~10 nodes. A recently added node experience the 'Received UDP packet from unknown source' problem. I read in the faq this is probably caused by a NAT rule on wither side, but I dont have such rules. The thing is that IP in the 'Received UDP packet from unknown source ' message is exactly what I have configured. The problem solves itself with