similar to: traffic shaping and classes

Hello Shorewall users, I have some questions I am hoping someone can answer. I have searched around the archives but so far I have been unable to find answers. I am trying to configure traffic shaping on my router/firewall box running Shorewall 3.0.5/kernel 2.4.31 and have run into some problems/questions. My basic set up is: 1500/256kbit ADSL (PPPoE/ppp0) -> Shorewall box

Hi, I am running OpenVPN where i have one central hub VPN server, and multiple spoke VPN clients. I can ping from each client to the server and each client to computers on the subnet which the server resides (192.168.2.0/24) so it works ok there. I cannot however, ping from one client to another client. I guess the packet path would go: clienta -> vpn -> shorewall/router -> vpn ->

>Date: Sun, 17 Apr 2005 13:28:05 -0400 >From: "ryanag@zoominternet.net" <ryanag@zoominternet.net> >Subject: Re: [Shorewall-users] dumb, dumb question **follow-up on > support-request documentation** >To: Tom Eastep <teastep@shorewall.net> >Cc: Mailing List for Shorewall Users > <shorewall-users@lists.shorewall.net> >Message-ID:

the establishment of an openvpn link sometimes fails. I tracked it down to network traffic with wrong Sourceport in the answer packet (should be 1300 not 1024): 2 1.119309000 aaa.185.165 bbb.162.192 UDP 58 Source port: 1300 Destination port: 1300 3 1.119446000 bbb.162.192 aaa.185.165 UDP 66 Source port: 1024 Destination port: 1300 and a collateral entry in the connection tracking table

Hi All, Is it possible to establish site-to-site VPN using dynamic IP addresss assigned by ISP ? If yes, I would like to request a sample ipsec.conf for such scenario... Thanks and warmest regards aslay ################################################### # This message has been scanned for viruses and # # dangerous content by Pensteel Digital Solutions # # Open Source Security Server,

Good day, I have gone through a couple of the HOWTO''s on how to get this to work, but I am still sitting with a very strange (for me) issue. If two clients connect via OpenVPN (bridged), they can access each other without any problems, but neither of them can access the server, nor any system behind it. I am fairly sure it is a Shorewall issue, but I am very new to Shorewall, having

Hi All, I''m using Shorewall 3.0.4 and I''m wondering if it is possible to do traffic shapping on only one interface from a bridge. The firewall has got 3 NIC, eth0, eth1, eth2. eth0 and eth2 are bridged, but if I''m right, when you specify a traffic rate for a link, you do it for the interface. In my case, eth0 and eth2 do not appear in the interface file, but it is

Hello Mailinglist, please excuse my bad english - but I am not a native speaker. My Network looks like this: Internet --- dyn. IP --- Firewall (shorewall) --- LAN (192.168.X.X) No I try to connect my iphone (from mobile Internet G3) over VPN (l2tp/ipsec) with the firewall. But I can´t open the necessary Port 1701. /var/log/syslog ... Dec 30 00:24:29 router kernel: [226128.293757]

Hi folks, I''ve added a couple of ''help wanted'' ads to our SourceForge project. You can see them at http://sourceforge.net/people/?group_id=22587 I''ll add more as i have the opportunity. If you can think of other jobs we need to assign, please let me know. -- Paul <http://paulgear.webhop.net> -- Did you know? Using accepted quoting conventions makes

Dear List! I use a shorewall 2.0.8 on a Debian sarge system. I use a DSL connection to the Internet (ppp0 - eth1 to the modem) and a bridge to the local lan. The bridged config i''ve made with bridge.html from the shorewall site. The Bridge is between local net and a openvpn tap device. This works. I ccan make tunnels, and a can make a lot of things through the firewall. I can get a list

Dear list, I''m running Shorewall on a dedicated Fedora 7 box. Shorewall is working well as an office DSL router (dynamic IP) with loc and dmz zones. I am now trying to configure IPSec to connect a VPS, "casp", with a static IP to both the firewall and to the loc network behind it. The host to host SA works fine. However, pings from "loc" to "casp" can be

http://shorewall.net/pub/shorewall/Beta ftp://shorewall.net/pub/shorewall/Beta This is Beta 1 plus fixes to the problems reported by Michael Van Damme and Jochen Schlick. -Tom -- Tom Eastep \ Nothing is foolproof to a sufficiently talented fool Shoreline, \ http://shorewall.net Washington USA \ teastep@shorewall.net

Hi All, As you probably all know :-) I''m trying to do the multi-isp thing. I''ve resolved my last issue with the route_rules as suggested by Tom and Jerry suggested. Lately I have been seeing "transient" (I say transient because the problem will persist for a while and then magically clear itself up some number of minutes later) situations where my gateway will log:

I have an old Pentium II which I use as a gateway and firewall for a home network. The external interface is a modem on ppp and the internal interface is ethernet. I have had this setup running successfully for many years starting with the early 2.x series Shorewall. My ISP recently changed my dial-up ''phone number and presumably also the system at the other end of my modem (they

Hi guys, I''m not sure where to post for help on this one, shorewall or lvs, I''ll start with shorewall (only cause Tom is a gun at this stuff, and is polite enough to tell me to bugger off to the LVS list if I''m posting in the wrong one ;) I have a single box that is my router/firewall/LVS. Internet -- eth0 - router/firewall - eth1 --- internal lan | eth2

Given that a 4-day silence on this list is almost unprecedented, thought I had better send a test post. Apologies for the spam. ------------------------------------------------------------------------------ Check out the new SourceForge.net Marketplace. It is the best place to buy or sell services for just about anything Open Source. http://p.sf.net/sfu/Xq1LFB

I have two feeds, one with a static IP and one with a dynamic IP. How can I configure a Multi-ISP setup with the dynamic IP, or can I? I don''t think the gateway will change, just the interface IP. -- Chris Mason NetConcepts (264) 497-5670 Fax: (264) 497-8463 Int: (305) 704-7249 Fax: (815)301-9759 UK 44.207.183.0271 Cell: 264-235-5670 Yahoo IM: netconcepts_anguilla@yahoo.com --

I think that the time has come for me to back off a bit from my involvement with Shorewall. I just don''t have enough cycles (or energy) to keep up the pace of the last several months. As a consequence, I''m going to do the following: 1. I''m going to stop personally supporting the entry level tools (samples and quick start guide). These tools are a source of constant

Hi all! I am a long time lurker, but have not posted until now. My old trusted firewall machine broke a couple of weeks ago and I replaced it with a XEN domU that is using DNAT and has two interfaces. The firewall domU and the FTP server domU are both guests on the same dom0. All three machines are running Debian/etch (stable) and Shorewall has version 3.2.6. I can''t get FTP to work