similar to: unsubscribe

Problems building celt-0.5.2 for blackfin. Use the following to configure: #!/bin/sh # bfinconf # Set up configuration to cross compile on blackfin ./configure \ --host=bfin \ --enable-fixed-point \ CC=bfin-uclinux-gcc \ CFLAGS='-O2 '\ '-mfast-fp '\ '-ffast-math '\ '-Wall -Dlinux '\ '-D__linux__ '\ '-fno-strict-aliasing '\

On Sat, Nov 30, 2019 at 06:49:29PM +0800, zxs11289 wrote: > I face a problem on KVM using virt-df。 I have two computer,they > have installed tools for KVM. The computer（ip 15）has no virtual > machine and computer（ip 33）has two virtual machines。on the > computer(ip33)， i run the command “virt-df” if on the computer(ip15)， > i run the command “virt-df --connect

Hello! I'm new to the list, so first I'd like to say hi to everybody! Is there somebody interested in helping with porting Speex on dsPIC series of Microchip's microcontrollers? I was looking at 30F6014A with 144 kB of flash and 8 kB of ram, fixed point DSP core and capable of 30 MIPS. If only one narrowband rate was selected and everything unnecessary stripped down, perhaps it could

Hi! It may be a little OT but i'm searching for a c/c++ programmer for the development of a remote controlled multimedia player that would run under CentOS with Aja OEM card. We'd use this player in our fully automatic TV broadcast system. We currently have a player (developed in house) that works mostly ok on Winblows but it lacks many features like remote monitoring (SNMP or

Currently my ethernet bridge has 2 intel 100mps NIC's that are both part of a bridge. ( I followed the sample setup on the bridge.sf.net page.) In addition to this I would like to access the internet from within the ethernet bridge and when using the sample instructions I have no gateway setup and no default route (0.0.0.0). I know this data has to be attached to the bridge device and not to

Hello I did the following commands and resulted in a segmentation fault. [root@localhost ~]# mkfs.btrfs /dev/sda6 WARNING! - Btrfs Btrfs v0.19 IS EXPERIMENTAL WARNING! - see http://btrfs.wiki.kernel.org before using fs created label (null) on /dev/sda6 nodesize 4096 leafsize 4096 sectorsize 4096 size 46.93GB Btrfs Btrfs v0.19 [root@localhost ~]# mount /dev/sda6 /mnt/btra [root@localhost ~]#

> This message is in MIME format. Since your mail reader does not understand this format, some or all of this message may not be legible. --B_3294209241_521622 Content-Type: text/plain; charset=us-ascii Content-Transfer-Encoding: 7bit I have been unable to find any discussion regarding this issue, but I have been able to reproduce it on two different machines. Both computer are Macs running