similar to: PCI device not properly reset after VFIO

The attached patches allow the pciback module to perform a reset whenever a PCI device is: - attached to the pciback module, as so: echo "0000:01.07.0" > /sys/bus/pci/devices/pciback/bind - detached from the pciback module, as so: echo "0000:01.07.0" > /sys/bus/pci/devices/pciback/unbind - and when the guest is done with (internally when the guest is not using

This is a design and an initial patch for kernel side for AER support in VFIO. 0. What happens now (PCIE AER only) Fatal errors cause a link reset. Non fatal errors don't. All errors stop the VM eventually, but not immediately because it's detected and reported asynchronously. Interrupts are forwarded as usual. Correctable errors are not reported to guest at all.

This is a design and an initial patch for kernel side for AER support in VFIO. 0. What happens now (PCIE AER only) Fatal errors cause a link reset. Non fatal errors don't. All errors stop the VM eventually, but not immediately because it's detected and reported asynchronously. Interrupts are forwarded as usual. Correctable errors are not reported to guest at all.

Legacy virtio devices always bypassed an IOMMU, so using them with vfio was never safe. This adds a quirk detecting these and disabling VFIO unless the noiommu mode is used. At the moment, this only applies to virtio-pci devices. The patch might make sense on stable as well. Michael S. Tsirkin (2): vfio: report group noiommu status vfio: add virtio pci quirk

Legacy virtio devices always bypassed an IOMMU, so using them with vfio was never safe. This adds a quirk detecting these and disabling VFIO unless the noiommu mode is used. At the moment, this only applies to virtio-pci devices. The patch might make sense on stable as well. Michael S. Tsirkin (2): vfio: report group noiommu status vfio: add virtio pci quirk

On Mon, 18 Apr 2016 12:58:28 +0300 "Michael S. Tsirkin" <mst at redhat.com> wrote: > Modern virtio pci devices can set VIRTIO_F_IOMMU_PLATFORM > to signal they are safe to use with an IOMMU. > > Without this bit, exposing the device to userspace is unsafe, so probe > and fail VFIO initialization unless noiommu is enabled. > > Signed-off-by: Michael S.

On Mon, 29 Aug 2016 21:52:20 -0600 Alex Williamson <alex.williamson at redhat.com> wrote: > On Mon, 29 Aug 2016 21:23:25 -0600 > Alex Williamson <alex.williamson at redhat.com> wrote: > > > On Tue, 30 Aug 2016 05:27:17 +0300 > > "Michael S. Tsirkin" <mst at redhat.com> wrote: > > > > > Modern virtio pci devices can set

On Mon, 18 Apr 2016 12:58:28 +0300 "Michael S. Tsirkin" <mst at redhat.com> wrote: > Modern virtio pci devices can set VIRTIO_F_IOMMU_PLATFORM > to signal they are safe to use with an IOMMU. > > Without this bit, exposing the device to userspace is unsafe, so probe > and fail VFIO initialization unless noiommu is enabled. > > Signed-off-by: Michael S.

On Mon, 29 Aug 2016 21:52:20 -0600 Alex Williamson <alex.williamson at redhat.com> wrote: > On Mon, 29 Aug 2016 21:23:25 -0600 > Alex Williamson <alex.williamson at redhat.com> wrote: > > > On Tue, 30 Aug 2016 05:27:17 +0300 > > "Michael S. Tsirkin" <mst at redhat.com> wrote: > > > > > Modern virtio pci devices can set

Driver init call graph under baremetal: driver_init-> msix_capability_init-> msix_program_entries-> msix_mask_irq-> entry->masked = 1 request_irq-> __setup_irq-> irq_startup-> unmask_msi_irq-> msix_mask_irq-> entry->masked = 0 So

On Tue, 30 Aug 2016 05:27:17 +0300 "Michael S. Tsirkin" <mst at redhat.com> wrote: > Modern virtio pci devices can set VIRTIO_F_IOMMU_PLATFORM > to signal they are safe to use with an IOMMU. > > Without this bit, exposing the device to userspace is unsafe, so probe > and fail VFIO initialization unless noiommu is enabled. > > Signed-off-by: Michael S.

On Tue, 30 Aug 2016 05:27:17 +0300 "Michael S. Tsirkin" <mst at redhat.com> wrote: > Modern virtio pci devices can set VIRTIO_F_IOMMU_PLATFORM > to signal they are safe to use with an IOMMU. > > Without this bit, exposing the device to userspace is unsafe, so probe > and fail VFIO initialization unless noiommu is enabled. > > Signed-off-by: Michael S.

This is a design and an initial patch for kernel side for AER support in VFIO. 0. What happens now (PCIE AER only) Fatal errors cause a link reset. Non fatal errors don't. All errors stop the VM eventually, but not immediately because it's detected and reported asynchronously. Interrupts are forwarded as usual. Correctable errors are not reported to guest at all.

This is a design and an initial patch for kernel side for AER support in VFIO. 0. What happens now (PCIE AER only) Fatal errors cause a link reset. Non fatal errors don't. All errors stop the VM eventually, but not immediately because it's detected and reported asynchronously. Interrupts are forwarded as usual. Correctable errors are not reported to guest at all.

Hi everyone, I would like to ask what the current status of FLR, or better of FLR emulation is in latest Xen and if we can expect better support in the future. I''m asking because with xl (latest build and traditional qemu, not upstream), I always had problems with rebooting domUs which have vga cards passed through to them, because appearently they don''t get reinitialized and

> -----Original Message----- > From: Wood Scott-B07421 > Sent: Tuesday, July 16, 2013 5:01 PM > To: Yoder Stuart-B08248 > Cc: Wood Scott-B07421; Alex Williamson; Alexander Graf; Bhushan Bharat-R65777; Sethi Varun-B16395; > virtualization at lists.linux-foundation.org; Antonios Motakis; kvm at vger.kernel.org list; kvm- > ppc at vger.kernel.org; kvmarm at lists.cs.columbia.edu

> -----Original Message----- > From: Wood Scott-B07421 > Sent: Tuesday, July 16, 2013 5:01 PM > To: Yoder Stuart-B08248 > Cc: Wood Scott-B07421; Alex Williamson; Alexander Graf; Bhushan Bharat-R65777; Sethi Varun-B16395; > virtualization at lists.linux-foundation.org; Antonios Motakis; kvm at vger.kernel.org list; kvm- > ppc at vger.kernel.org; kvmarm at lists.cs.columbia.edu

This is an attempt to allow enabling IOMMU for DMA. Design: - new feature bit IOMMU_PLATFORM which means host won't bypass IOMMU - virtio core uses DMA API if it sees IOMMU_PLATFORM - add quirk for vfio to disable device unless IOMMU_PLATFORM is set or the no-iommu mode is enabled - while I'm not sure how it will be used, it seems like a good idea to also have

This is an attempt to allow enabling IOMMU for DMA. Design: - new feature bit IOMMU_PLATFORM which means host won't bypass IOMMU - virtio core uses DMA API if it sees IOMMU_PLATFORM - add quirk for vfio to disable device unless IOMMU_PLATFORM is set or the no-iommu mode is enabled - while I'm not sure how it will be used, it seems like a good idea to also have

Since quirk_nvidia_hda() was added there's now two nvidia device functions on any laptops with nvidia GPUs: the HDA controller, and the GPU itself. Unfortunately this has the sideaffect of breaking quirk_reset_lenovo_thinkpad_50_nvgpu() since pci_reset_function() was using pci_parent_bus_reset() to reset the GPU's respective PCI bus, and pci_parent_bus_reset() does not work on busses which