similar to: Ndiswrapper refuses to install?

I know, I know... don't use the non-standard kernels unless you have to... BUT: I have a D-Link N150 USB card. Bus 001 Device 004: ID 0846:9030 NetGear, Inc. WNA1100 Wireless-N 150 [Atheros AR9271] This isn't supported in C5, but it is supported in newer kernels (ath9k_htc). So let's try NDISwrapper: # rpm -i kmod\-ndiswrapper\-1.56\-1.el5.elrepo.i686.rpm

Hi Folks, I'm trying tio install WLAN - USB - Stick Netgear WG111v3. ndiswrapper -i wg111v3 works. I can see ndiswrapper -l wg111v3: driver installed device (0846:4260) present But after modprobe ndiswrapper the system freezes. Troublshooting on ndiswrapper-sites says: It's a problem of "kernel is using 4K stacks (CONFIG_4KSTACKS)" Solution: recompile the kernel.

This is an abbreviated version of an e-mail that I also posted to the ndiswrapper mailing list. Compressing the long story, I ran into the same problem using CentOS 5 as I had with Fedora Core 6 and ndiswrapper: my laptop (HP Pavilion zv6000 series with a Broadcom BCM43xx wireless NIC) would lock up or spontaneously reboot after a few hours if I brought up the wireless interface. I also

Greetings: I'm just installed Centos-4 on an IBM T-21 laptop. So far so good. Now I'd like to pop in a wireless lan adapter. I'm looking at a buying a Linksys WPC54G adapter (although I haven't done so yet). After doing some searching, it looks like the best way to get this card working is via ndiswrapper [http://ndiswrapper.sourceforge.net] and then to use Windoze

Hi - I'm trying to get wireless running on CentOS 4.7 on a dual core laptop (latitude-e4500) for an employee. I'm having trouble with building dkms-ndiswraper-1.54-1.el4.rf - enclosed are the errors messages. The kernel was rebuilt to disable CONFIG_4KSTACKS. The errors prior to rebuilding the kernel are identical to the errors after rebuilding the kernel and rebooting - minus the error

Hi people, I am using CentOs 4.3 and i'm trying to use ndiswrapper, but i don't obtain make it to run. my problem is with "invalid format" of module ? any suggestions ? thanks.

Hello all, Has anyone gotten dom0 to work with ndiswrapper? I''m a newbie, but I''ve managed to install dom0 and get it to boot, then compile a new dom0 and get that to boot too. I''ve turned on the appropriate .config params for wireless (as far as I know). I''ve downloaded/compiled/installed the latest ndiswrapper. When I ''modprobe

Hello, I had installed CentOS 5.0 on my desktop PC having a Realtek 8180L based PCI wireless card. Since the drivers for this chip are not available in the kernel, I created RPMs for ndiswrapper-1.43 from the source code and installed them. I could configure the wireless card and use it but invariably the system freezes after sometime. No such thing happens if the wireless card is disabled. In

WPA-2 (WPA Enterprise) fails with the new kernel(s) using ndiswrapper and wpa_supplicant. I haven't tried other authentication modes because that entails changes in the wireless setup which I am loathe to make right now. (It's a Broadcom mini pci card, so I have to use ndiswrapper with this Dell laptop. Bummer!). Rebuilding the newest wpa_supplicant rpm from the FC5 source rpm's

Hello, I have the exact same problem as mentioned in this post,(http://lists.xensource.com/archives/html/xen-users/2005-06/msg00221.html) (or see the bottom of this post) Yet the conversation was continued elsewhere, is this a bug or somthing stupid.. or more importantly is there a solution? Thanks! ~Rob ---(Quote From Archives)--- "Hi Folks, I am trying to get my wireless network card

I'm using CentOS 5 (w/all latest updates as of 2008-01-06) on an HP laptop -- in fact, the exact laptop described here: http://wiki.centos.org/HowTos/Laptops/HP/Pavilion-ze5300_Series Ever since I switched from SHARED to OPEN authentication (and hence from using ndiswrapper to the bcm43xx module, as explained on that wiki page), I've been having packet loss and/or collision on the

Hi Folks, I'd like to install my USB-WLAN-Stick Netgear WG111v3. Ndiswrapper works correct after installing Kernel-Modules from atrpm ndiswrapper-kmdl-2.6.18-53.1.19.el5.centos.plus-1.52-16.el5.i686.rpm. But by calling wpa_supplicant with wpa_supplicant -i wlan0 -D wext -c /etc/wpa_supplicant/wpa_supplicant.conf -d machine freezes. My wpa_supplicant.conf:

I am having trouble using the realtek wifi chip in my new tp-link usb wifi dongle. Upon plugging it, the device gets registered by the kernel (in /var/log/messages), but that's about it, no network device is being created (iwconfig does not see it, nothing else works). A few google searches later I found out that this realtek chip is not supported by the kernel and requires a driver, and that

CentOS Community, Would someone who is familiar with reading boot messages and kernel errors be able to assist with advising me on what the following errors might mean in dmesg. It seems to come up randomly towards the end of the logfile. ------------[ cut here ]------------ WARNING: at arch/x86/kernel/cpu/mtrr/generic.c:467 generic_get_mtrr+0x11e/0x140() (Not tainted) Hardware name: empty

Has anyone had any luck with getting the Dell TrueMobile 1400 A/B/G wireless card working under Linux? I have experimented with ndiswrapper, i have had nothing but problems trying to get it to work. I was wondering if anyone has found a native Linux driver for the card. It uses a Broadcom 4309 chipset. Regards, Peter

I''ve solved my earlier ndiswrapper problems, which turned out to be ndiswrapper-related rather than xen-related. However, I''m still unable to start the xend daemon for some reason. from dom0... root@Eureka:~ # /etc/init.d/xend start ......... root@Eureka:~ # fine, no errors there. root@Eureka:~ # cat /var/log/xend.log [2005-07-15 10:52:47 xend] INFO (SrvDaemon:610) Xend

Hi Folks, I am trying to get my wireless network card work under dom0 of XEN. I could successfully install the ndiswrapper drivers and could see it being associated to AP. However I amn''t able to transmit any packets outbound. I could''nt even ping the AP. Interestingly when I run a tcpdump I can see few broadcast packets on the interface. There no rules in iptables for nat or

Hi, I'm attempting to port an application which uses the Cypress CyAPI, which is Windows only, though I don't know if wine can handle device drivers or such low-level stuff. Anyway, I tried to develop a little prototype to run under wine, hoping it would provide with some insight. But this is the output I get: fixme:setupapi:SetupDiGetClassDevsW : returning empty list

I've just installed CentOS 5.3 on my Dell laptop and it seems to have detected and set-up my wireless card (BCM 4311) correctly as eth1. However, so far I haven't been able to activate it and have read the wiki http://wiki.centos.org/HowTos/Laptops/Wireless#head-320d6fcf09b7e16e0b15d19ef76adcb023a95938 which indicates that this card isn't actually supported in CentOS - but there has

Hi, I have a laptop DELL M90 with an Intel PRO/Wireless 3945ABG card. I'm using centOS 5.1 kernel 2.6.18-53 i386. I installed ndiswrapper v 1.52 I installed the driver http://ftp.us.dell.com/network/R164255.EXE The wireless-tools is v 28.2 When I trying to connect to my wireless access point with encryption key disabled everything work fine !!!! When I enabled the encryption key on my