similar to: Can I set up VMs in a "Flat" network?

I am not sure if we can not send attachments to the mailing list. There were quite a lot replies before, but I got nothing back since attachements was added. I will remove the attachments and send it again. Please have a look at the email below. Thanks for your help. --- Dear All, Thanks for all your help. I will put all the comments together. Please have a look if there is any clue on such

Hi, we are having a problem with NFS using RDMA protocol over our FDR10 Infiniband network. I previously wrote to NFS mailing list about this, so you may find our discussion there. I have taken some load off the server which was using NFS for backups, and converted it to use SSH, but we are still having critical problems with NFS clients losing connection to the server, causing the clients

> On 29 Jul 2015, at 10:02, Ralph Böhme <rb at sernet.de> wrote: > Hm, works for me: > > mac$ mount | grep smb > //ralph at 10.10.11.100 <mailto:ralph at 10.10.11.100>/AAPL on /Volumes/AAPL (smbfs, nodev, nosuid, mounted by ralph) > mac$ touch /Volumes/AAPL/test > mac$ xattr -w foo bar /Volumes/AAPL/test > mac$ xattr -l /Volumes/AAPL/test > foo: bar >

Alex, On Sat, Oct 22, 2016 at 07:30:01PM +0100, Alex Crow wrote: > I applied the patch to a new build of Sernet 4.4.6 SRPM. I could still > open the file from both hosts, and in fact this time I could actually > open it on the same host without any problems: I don't see where you're opening the file twice from one smbclient below. Am I missing something? And then there's no

On Tue, Jul 28, 2015 at 02:55:32PM +0200, Michal Moravec wrote: > Hello > > I am trying to integrate OS X 10.10.4 clients into existing Samba infractructure run by our IT department. > We are currently using Samba 4.2.3. > File share is stored on iSCSI array with ext4 filesystem which should support both ACL and XATTR. > > We are trying to setup vfs_fruit module to avoid

On 23/10/16 10:00, Ralph Böhme wrote: > Alex, > > On Sat, Oct 22, 2016 at 07:30:01PM +0100, Alex Crow wrote: >> I applied the patch to a new build of Sernet 4.4.6 SRPM. I could still >> open the file from both hosts, and in fact this time I could actually >> open it on the same host without any problems: > I don't see where you're opening the file twice from

I''m very new to shorewall. My setup is IP Gateway (CentOS 4 + Shorewall) with 3 NIC cards. Shorewall works great on the firewall machine. Bind also works (local net machines get IPs fine). Under firestarter, all works great. With shorewall, the loc machines can not route past the firewall. They can connect to the firewall, but not past it. Exactly what information should I post to get

Dear Centos Users: I installed Centos 7 on my server a few months ago. While using ssh, there is always a strange message "Write failed: Broken pipe?. It forces quit of SSH. It?s really annoying as it happens very often with irregular time interval - from a couple of minutes to a few hours. I have been working using Linux (Red Hat, Fedora and Centos) over 15 years. This didn?t happen for me

Hello I am trying to integrate OS X 10.10.4 clients into existing Samba infractructure run by our IT department. We are currently using Samba 4.2.3. File share is stored on iSCSI array with ext4 filesystem which should support both ACL and XATTR. We are trying to setup vfs_fruit module to avoid possible performance problems on OS X clients. We do NOT user netatalk. Current vfs_fruit config:

Hi Ralph, I applied the patch to a new build of Sernet 4.4.6 SRPM. I could still open the file from both hosts, and in fact this time I could actually open it on the same host without any problems: host 1: smbclient -U ajc //172.31.0.120/ifa_v ... smb: \jmi\Corporate Accounting\ISL Ltd Accounts\2016\1609\> open "201609 213_ ISL Balance sheet variance analysis.xls" open file

I am getting the following message when Shorewall stops can anybody shed any light on this message and where I should be looking? Thanks root@bobshost:~# shorewall stop Loading /usr/share/shorewall/functions... Processing /etc/shorewall/params ... Processing /etc/shorewall/shorewall.conf... Loading Modules... Stopping Shorewall...Processing /etc/shorewall/stop ... IP Forwarding Enabled

Hi, I have a question about estimating IRT models by using nlme, not just rasch model, but also other models. Behavior Research Methods <http://www.springerlink.com/content/1554-351x/> Volume 37, Number 2 <http://www.springerlink.com/content/1554-351x/37/2/>, 202-218, DOI: 10.3758/BF03192688 Using SAS PROC NLMIXED to fit item response theory models (2005). Ching-Fan