similar to: Network card help please

Hi, One of my pbx's seems to be having some new issues. crackling interference on the zap channels running through the channel bank, and I noticed that these happen when I hit an "irq miss" in zttool: Current Alarms: No alarms. Sync Source: Digium Wildcard T100P T1/PRI C IRQ Misses: 82695 Bipolar Viol: 0 Tx/Rx Levels: 0/8 3 Total/Conf/Act:

Hi list, I'm planning to buy a mobo (z170-K) that has Realtek 8111GR (nic). I've tried to search on google about support on C7 but can't fine anything. There is a way to check if supported? Is the Realtek 8111GR supported or I must change mobo? Thanks in advance.

I need to get a second ethernet card for my HP Proliant CentOS server, to attach a LinkSys WRT54GL router to. I see that there are many Realtek RTL8169S gigabit cards going for a song on eBay. Is anyone using one of these under CentOS? Do they work OK? (I used to have a couple of Realtek cards - not gigabit - and they worked fine.) Or does anyone have a strong recommendation for other cards? Any

Hello everyone: Over the past few years I have been a happy samba user, running samba on Redhat / FC platforms. Recently I upgraded hardware, and Samba hasn't been performing well at all.. which makes me sad :-( The new hardware is Asus P5B board with a dual-core intel processor. This board has an onboard Realtek RTL8111/8168B gigabit ethernet controller, which was a hassle to setup.

Realtek is "real" good about getting drivers for their chips into the kernels as soon as possible. They are one of the few vendors that I have never had a problem with built in support... Mike McCarthy On 06/03/2016 08:03 AM, Phil Manuel wrote: > You can get the Linux driver from >

Can anyone shed some light on this subject? I don't have a clue where to begin looking. It's RHL 6.0, Samba 2.0.3, stock kernel. Kevin --- |\ _,,,---,,_ ZZZzz /,`.-'`' -. ;-;;,_ |,4- ) )-,_. ,\ ( `'-' Kevin Alan Pieckiel '---''(_/--' `-'_) kapieckiel@harding.edu (This message was written with

Had to replace dying cpu and mobo, so also replaced IDE with new SATA drive. Installed from latest ISO onto SATA and can't get networking to lease an IP address from my ISP (Comcast). The network utility always comes up with a private address (192.168.0.2) instead of Comcast IP. To add to confusion, if I boot into old IDE drive, I get proper network connection to internet, but lose my

Hi, I'm trying to get our 30 node cluster booting from remote server via pxelinux but have problems with the following mobo / switch combination. linksys srw2024 switch + asus a8n-vm csm mobo Maybe somebody saw similar problems elsewere and can recomend any solution. mobo bios is flashed to the newest available one. An extremly simplified test setup which shows our problem: PC1 ->

One last shot in the dark: what if you reboot the router in front of the node in question? Sometimes it was surprised, when managing different mac addresses on the same adapter. I might be missing some parts, but did the mobo work before? Best regards Zoran

HI zytor, I hope you can help me. I have above network chipset on a Mitsubishi im-2000 mobo. I don't see an actual chip on the mobo w/ this ID so I suspect it embedded in the mobo BIOS or in one of the 3 Intel chips. I am attempting to use LTSP to boot a workstation w/ above NIC chipset. It has imbedded boot to net software (Intel Landesk service agt v.99b) using PXE. I can't get it

Anyone have any luck RMAing a Sipura phone since the Cisco take over? Sipura only has support via email or fax to end users and I haven't gotten a response to either for over 2 months. Linksys Support will jump you through all their scripted hoops to resolve your problem (they hope if they speak with a thick enough accent and make repeat the same steps over and over again that you will just

Ubuntu 8.04, Wine installed & Reaper etc all playing back fine, but no audio input. No audio input available pre Wine install in eg; Audacity & Ardour. Used Prefs > Sound & set all to ALSA & MAudio ALSA where defined. Tried Wine > Audio Config - freezes whole system & doesn't resolve. G'byte MoBo Realtek card disabled in Bios, so only 1 audio device in operation

Hey, I had a problem with rebooting XP and joining the samba domain, which was controlled by my gentoo linux box. I worked for days for a solution, and found it....!!!! The problem was that I could join the domain fine, but had to reboot, and then found i was rejected from joining then. It appeared like the domain was invisible to the XP box. I pulled my hair out, scoured the web

Hi all, I''ve just installed a new Xen setup, ubuntu gutsy (with xen kernel package, so I guess that''s a complete replacement). Mostly works nicely, i think Xen''s great. I''ve just hit a snag when trying to transfer a large amount of data to the machine however, i''m using a PCI DLink gigabit network card (as the mobo onboard is the infamous realtek

You can get the Linux driver from http://www.realtek.com/downloads/downloadsView.aspx?Langid=1&PNid=5&PFid=5&Level=5&Conn=4&DownTypeID=3&GetDown=false#RTL8111B/RTL8168B/RTL8111/RTL8168%3Cbr%3ERTL8111C/RTL8111CP/RTL8111D%28L%29%3Cbr%3ERTL8168C/RTL8111DP if you can't find it under C7 Regards On Fri, Jun 3, 2016 at 8:11 PM, Alessandro Baggi <alessandro.baggi at

Hello list 6 centos I wish you a very good year for this festive period I am writing to report a problem I encounter with my wireless card realtek 8150 the installer does not detect the device so the /etc/sysconfig/network-script/ifcfg-wlan0 is absent I can not find the driver for the deposit elrepo No I have in any case managed to detect my peripheique by the system Despite my many attempts

I'm looking at setting up a new machine to run CentOS 5 and a few VMWare machines to test Windows XP, Vista, and 7. I'm working with a custom PC shop and they've recommended I use either the ASUS PT6 or Intel DX58SO. Any feedback good or bad on either of these? Thanks! --Chris

Hello all, I've posted on this problem before. Well here goes again. I have an intel mobo with a p4 2.4ghz proc, 1GB Ram. It has built-in ethernet and vga and 6 pci slots. I dreamed of making this my household communications server: internet router, firewall, vpn and asterisk. Everything works except the TDM fxs card. Well it works for a little while and it dies: no dialtone, no

Hi all, I swapped a Realtek 8139 100M Net Card for a Realtek 8169 Gig Net card in a Centos 5.6 system. After reconfiguring the network settings I find that on boot up the 8169 interface does not start. The startup script says something like "The 8169 is not available..." ifconfig -a shows a device with the right mac address called __tmpsomethingorother I can get it going if I

Hi I change eth1 from realtek to dlink but the centos is showing eth2 instead of eth1 In another version of linux, I can change 70-persistent-net.rules but I check /etc/udev/rules.d/70-persistent-net.rules but it doesn't have the file 70-persistent-net.rules please help Thank you Send instant messages to your online friends http://uk.messenger.yahoo.com