similar to: Sip 400 bad request - broadvoice error

Ok, My provider is sending a call to me via ULaw but Asterisk isn't picking up on this, I've only allowed ulaw, I disallow=all and then allow=ulaw in my sip.conf and that's the only thing I allow, but when my provider sends me the requests, I get an error about No Compatible Codecs: 17 headers, 8 lines Using latest request as basis request Sending to 67.19.245.213 : 5060

Hi all, I am using * as a PBX for a Broadvoice VoIP account. It had been working well since about last November, although not perfectly (similar disconnection problems, although I am pretty sure it had to do with my PPPoE setup, but I think these issues were resolved). As of a few weeks ago, though, I started having serious problems. Basically, I can start up * and connect to Broadvoice and

-------- Original Message -------- Subject: Re: [Asterisk-Users] BroadVoice configuration changes for Outbound Date: Sun, 06 Mar 2005 19:11:22 -0500 From: MF Hulber <mark@hulber.com> To: Asterisk Users Mailing List - Non-Commercial Discussion <asterisk-users@lists.digium.com>, dan@mirrorlynx.com References: <200503060703.XAA12457@comand.net>

I finally got my incoming and outgoing to work on Broadvoice with a configuration file that is no where close to the one given by them. Here it Is (sip.conf). For others who have a working config could u please share so that I could compare. Thank You [broadvoice] type=friend username=[number] fromuser=[number] secret=[password] host=sip.broadvoice.com fromdomain=sip.broadvoice.com

I'm using Asterisk 1.0.4 with AMP and Broad Voice. I have that with only 5 XTen Lite phones. I'm able to call / etc with internal phones just fine. I can call outside Vonage Numbers, and other BroadVoice Numbers. I have vonage where I live (626) and can call that fine. However, other 626 numbers I get similar errors as below. However, everytime, I try to call cell phones, and or

Hi, I have two accounts with broadvoice. Now, I want to be able to distinguish between them. I though that this would be simple by adding "/EXTEN" at the end of the register statement. For example: register => num1:pass@sip.broadvoice.com/1000 Unfortunately, this is not working. When I call into my box I hear busy tone. My config looks like this: [root@voip asterisk]# cat sip.conf