similar to: CentOS 4 and laptop and wifi works

I have not installed the madwifi specific kernel stuff (kdml and hal-kdml) from atrpms. I have installed with wpa rpms. And my Atheros card is working with almost no work on my part (other than runing wpa_supplicant as a deamon). Nice!

Has anyone else had any problems with getting wifi to work after upgrade ? I am using ipw2200 on an HP laptop - was working under 4.3 Ian -------------- next part -------------- An HTML attachment was scrubbed... URL: <http://lists.centos.org/pipermail/centos/attachments/20060906/3a518796/attachment-0002.html>

I seem to be able to lock my machine by going into wpa_cli and asking it to 'reassoc'. The reason for question mark after "hard" is that debug information (caused by wlandebug and athdebug) is being printed on the console. The only way to get machine's attention is to hold power button for 8 seconds. Note: manual reassociation is just the handy way to reproduce the problem

I remember being a small part of and following this thread a few months ago. <http://lists.centos.org/pipermail/centos/2006-May/065091.html> I've been attempting a go at getting wpa_supplicant running on CentOS 4.3 and haven't had much luck. I'm assuming my failure is my lack of knowledge on the subject, but anyways. First, my normal setup is as follows: IBM Thinkpad R40

Hello, I just installed Centos 5.2 on my wife's IBM thinkpad T41 with Atheros wireless. It looks like I need to install madwifi to get the wireless to work. Our home wireless network uses WPA2 I found the EL5 rpms at atrpms, but there is no madwifi-kmdl rpms for kernel 2.6.18-92.1.6.el5. So, to get the wireless working on my home network, what's the shortest path from here? Install

What's the easiest path to having my Atheros wireless cards supported, particularly in C5? In the past, I've chosen to download source and build my own, but that's become a little tiresome. At one point, OpenSUSE was the easy option, but since 10.1 it's dropped madwifi. -- Cheers John -- spambait 1aaaaaaa at coco.merseine.nu Z1aaaaaaa at coco.merseine.nu Please do not

I went to the wiki and searched for both wireless and wifi and did not find anything related to wireless cards in CentOS. I think it would be stellar to have something similar to the laptops page but for wifi chipsets. I would propose it have three categories: FOSS chipsets Native driver but not FOSS chipsets (ie atheros via madwifi) NDIS Wrapper FSF has compiled somewhat of a list at

I rebuilt my notebook that has the atheros card in it, and forgot to save all of my setup to get it working. I am using dkms and the madwifi rpms from rpmforge. My modprobe.conf has a line: alias wifi0 ath_pci I can ifconfig wifi0 up But the command: /usr/sbin/wpa_supplicant wpa_supplicant -dd -D madwifi -i wifi0 -c /etc/wpa_supplicant/wpa_supplicant.conf fails. Now some of my old

The nice folks at work have just provided me with a new, really spiffy, ThinkPad. So, I''m trying to get wireless working under CentOS4 and I''m having trouble. First, I can''t seem to find any rpms to just install (this would be really nice). And, second, when I try to build it from the src.rpm that I pulled from the atrpms repository with "rpmbuild --recompile

This is a new Centos 5.1 install on a HP nc2400 (that use to run XP). Completely clean install; blew away the XP partitions... After applying all the updates, and configuring for the rpmforge repo, I used yumex to install dkms and the dkms-ipw3945, ipw3945-firmware, and ipw3945d rpms. lsmod|grep ipw shows: ipw3945 180391 1 ieeee80211 33417 1 ipw3945 and dmesg)grep

Hi, I am running Centos 4.1 on a Dell D610 with ipw2200. Any good howto for running wpa-psk? I have searched and not found much related to RHEL or CentOS. -- Thanks http://www.911networks.com

I've just acquired a use IBM Thinkpad R40 model 2722-GDM. I'm contemplating what to run on it, and longer-term the likely candidates are: Centos 5 SLE{D,S} 10 OpenSUSE 10.2 Kubuntu - the latest. Kubuntu - Long Life (aka 6.04, Dapper, ...) I've booted Knoppix 4 in it and most seems well, including the Atheros Wireless card Windows can't find. The major flies in the

Kudzu is not recognizing my Atheros card. Actually I was having this problem with the plus kernel and I fell back to 2.6.9-34.0.2 Running on ethernet until I can figure out what to update.

Hi Folks, I'd like to install my USB-WLAN-Stick Netgear WG111v3. Ndiswrapper works correct after installing Kernel-Modules from atrpm ndiswrapper-kmdl-2.6.18-53.1.19.el5.centos.plus-1.52-16.el5.i686.rpm. But by calling wpa_supplicant with wpa_supplicant -i wlan0 -D wext -c /etc/wpa_supplicant/wpa_supplicant.conf -d machine freezes. My wpa_supplicant.conf:

hi all, this is my first hit on the mailing list. hope i m posting in the right place. well, i have a dell vostro 1510 laptop with broadcom wifi adapter. n it doesnt work! :( i installed the wifi drivers with ndiswrapper. iwconfig shows the following. [root at laptop ~]# iwconfig lo no wireless extensions. eth0 no wireless extensions. sit0 no wireless extensions. wlan0

Hi, I've got a task to have a small number of laptops netboot Linux over WiFi. The kernel is loaded off the USB stick of cource, it's off topic for now. The WPA-supplicant daemon is started early by dracut off initrd. It works. Mostly. The problem is that upon shutdown systemd terminates all the processes FIRST and unmounts filesystems NEXT. Guess what? Upon termination,

Hi, I'll need to buy a new wireless card. I need a recommendation for PCMCIA wireless card that simply works with CentOS out of the box. By "works out of the box", I mean that it doesn't need ndis wrapper (or whatever it is called), kernel hacks, or whatever. Thanks

My OQO boxes have the AR5413 wifi chipset, so for the first time in quite a while, I again need to run madwifi. So I went looking for the dkms madwifi rpms, but could not find them. They use to be on rpmforge, as I recall. dkms is there. So have I lost some memory cells or have these rpms taken a hike?

hi , i just finished installing Cent OS 5.2 x64 on my thankpad my hardware list shows the following Atheros Communications Inc. AR5212 802.11abg NIC but when im trying to set up wireless network i cannot find the appropriate wifi card.. when adding wifi connection pls help many thanks, Sumit. -------------- next part -------------- An HTML attachment was scrubbed... URL:

I am using a Netgear MA401 with the wi driver, and am having trouble using wpa_supplicant to set static WEP keys. I have the wlan_wep.ko module loaded with wlan and wi built into the kernel. My wpa_supplicant.conf looks like this: ctrl_interface=/var/run/wpa_supplicant ctrl_interface_group=wheel network={ ssid="INTERNERD" scan_ssid=1 priority=1 key_mgmt=NONE