similar to: Looping Problem

Hello, I am new to samba and i would to well secure it. In smb.conf, I entered the following lines : hosts allow = 192.168.0.2 127.0.0.1 hosts deny = 0.0.0.0/0 bind interfaces only = yes interfaces = eth0 lo I thought that it would only listens on the local machine and my internal Lan (which is on eth0 192.168.0.1) but nmbd seems to always listen on UDP/137 and UDP/138 (netbios-ns and

Hi all, This is a very basic question, but I just can't figure out why R is handling a loop I'm writing the way it is. Here is the script I have written: grid_2_series<-function(gage_handle,data_type,filename) series_name<-paste(gage_handle,data_type,sep="_") data_grid<-read.table(file=paste(filename,".txt",sep=""))

Hi all, Forgive me for this basic question. I've been doing some research and haven't been able to figure out how to best do this yet. I have 75 variables defined as vector time series. I am trying to create a script to automate calculations on each of these variables, but I wasn't sure how to go about calling variables in a script. I am hoping to write a loop that calls a list of

Hi, I am running a correlation analysis on a temporal dataset. I was wondering if you would receive the same tau and p values running the function: MannKendall(x), where x is the dependant variable that changes with time as you would running: Kendall(d,x), where x is the exact same dataset as the x entered into MannKendall and d is the date on which the observation was made (assuming that

Hi all, When I attempt to run a script, I keep getting the error message shown below. I have seen from searching that the "Use of save versions prior to 2 is deprecated" could be an error resulting from a permissions problem, but I have been unable to find anything describing the "file has magnic number '# Coh'". The file I am attempting to read into the script is a

Hi, I am trying to create a loess smooth from hydrologic data. My goal is to create a smooth line that describes discharge at a certain point in time. I have done this using the 'lowess' function and had no problem, but I'm having some difficulty with loess. I am inputting the date ('date') and discharge ('q') values using the 'scan' function, then inputting

Ok, I''ve been chasing this for many days .. I have a server running 10 instances that periodically freezes .. then sometimes "comes back." I tried many things to try to spot the problem and finally found it by accident. It''s a little frustrating as typically the Dom0 and One (or two) instances "go" and the rest carry on .. and there is diddley squat when it